Operation
Power Save: Select Power Save from the Options menu to access the power management features of the
•
Always set this option to On. Doing otherwise may disrupt
Caution | communication between the projector and DHD Controller. |
|
•Auto Power Off: When this option is set to On, the projector enters standby mode after 15 minutes of inactivity (no input signal). Five minutes before this is to occur, the message “Enter STANDBY mode in 5 min.” appears
When set to Off, the projector remains in the “power on” state regardless of the presence or absence of an input signal.
Note | When you set the Auto Power Off function to Off, the LED function |
(refer to LED on page 71) is automatically set to On. |
Baud Rate: Select Baud Rate from the Options menu, then press the or button to select the projector’s
Runco Technical Support.
Fan Mode: If the projector is being used in a
Orientation: Refer to Adjusting the Picture Orientation on page 40.
Factory Default: To reset all projector settings (including image settings) back to their factory defaults, choose Factory Default from the Options menu. When the confirmation message appears, select All Reset to perform the reset or Return to cancel. This action is not undoable. Proceed with caution!
Note | The Factory Default command does not reset the Lamp Timer or |
OSD Language setting. |
72 | Runco |