Runco VX-6000D manual Connecting an External IR

Installation

Projector: The projector is equipped with an additional 12-volt trigger output. This trigger activates when the projector is turned on. Connect it to your retractable screen or other, 12-volt trigger-activated equipment as shown in Figure 3-15.

			HDMI IN
						+12V WIRED RS-232C
						IR
		100-240V
		AC INPUT
					(cylindrical,
					DC power
					supply-type
	to retractable screen					plug)
	or other, 12-volt			Sleeve = Ground
	trigger-activated
					Tip = +12V
	equipment
	Figure 3-15. 12-volt Trigger Output Connection (from Projector)
Connecting an External IR ➤	If infrared signals from the remote control cannot reach the DHD Controller due to
Receiver to the DHD	excessive distance or obstructions such as walls or cabinet doors, you can connect an
Controller	external IR receiver to the DHD Controller to extend the range of the remote control. See
	Figure 3-16.
				TRIGGERS
			1	2	3	IR Ring = +5V
						Tip = IR Input
						Sleeve = Ground
	Pb	Pr	Y	S-Video 1
	Component Video		Video	S-Video 2	RS-232 Out	RS-232 Control
	IR Receiver
						(3.5-mm
		Remote				mini phono
						plug)
		Control

Figure 3-16. External IR Receiver Connection

Note	When an external IR receiver is connected to the wired IR input, the
	built-in IR sensor on the DHD Controller is disabled.

38 Runco VX-6000d Owner’s Operating Manual