Adjusting the Height of the Picture
Use the adjuster release to adjust the angle of the projector and height of the picture. Minor adjustments can be made with the adjusters.
| Adjuster release |
| Adjusters |
1 | 1. Press the adjuster release and lift the |
projector to the desired angle with both hands.
• The adjuster legs will extend to the surface of the table.
2
3
Transporting the Projector
Use the carrying handle when carrying the projector
2.Remove your hand from the adjuster release.
•The adjuster legs will lock in position. Release the projector once you are sure the adjuster legs have locked in position.
3. Make any minor adjustments necessary.
•Turn the adjusters to further adjust the angle of the projector.
Returning the projector to its original position
•While holding the projector with both hands, press the adjuster release and slowly lower the projector to its original position.
Notes:
•Adjustable up to approximately 5° from the horizontal.
•When adjustments are made with the adjusters, the picture may become distorted, depending on the relative positions of the projector and the screen.
•After adjusting, in some cases, all of the adjusters’ feet may not be resting on the table.
To prevent the projector from wobbling, adjust the adjusters’ feet so that they firmly contact the table.
Cautions:
•Do not press the adjuster release when the adjuster legs are extended without firmly holding the projector.
•When lowering the projector, be careful not to get your fingers caught in the area between the adjusters and the projector.
•Do not hold the lens when lifting or lowering the projector.
When transporting the projector, press the handle release located on the side of the unit to expose the handle and then carry it by the handle as shown. To close the handle, push it back into the side of the unit.
Note:
Always put on the lens cap to prevent damage to the lens when trans- porting the projector.
Caution:
Do not lift or carry the projector by the lens or the lens cover as this may damage the lens.
carrying handle