Maintenance
Troubleshooting
If you try the troubleshooting procedures described in this section and the problem persists, you may have a malfunctioning projector. Refer to the technical support card that you received with your projector or contact the retailer where you purchased your projector. Also visit our web site at www.xeroxprojectors.com for additional technical information.
Problem: No image appears on the screen.
Check for one of these possible problems:
•Are the cables loose or not plugged in securely? Inspect the cable connections. Make sure the cables are plugged in securely.
•Are any of the pins on the cables bent or broken? Inspect the pins on the cable plugs to make sure none of the pins are bent or broken.
•Is the projection lamp securely installed? Check that the projection lamp is securely installed, especially if you just changed it. See the section “Changing the Lamp” on page 21 for details about the lamp installation.
•Is the power on? Check that the projector’s power switch is turned on and that the power cord is plugged in securely to a working power outlet.
•Is the lens cap still on? Make sure you have removed the lens cap from the lens at the front of the projector
Problem: The image is incorrectly displayed, or scrolls, or only partially displayed.
From the projector’s On Screen Display, select the Computer Image menu and select Auto Image so the projector can automatically adjust the image to provide the best possible results.
If the image is still not projected correctly, the resolution setting of your computer screen is too high (greater than 1024 x 768) and you must reset it.
For Windows 3.x:
1.In the Windows Program Manager, click the Windows Setup icon in the Main group.
2.Verify that your display resolution setting is less than or equal to 1024 x 768.
Xerox DP1011 User’s Guide | 23 |