Visioneer DP1011 manual Maintenance, Changing the Lamp, To change the lamp module

Page 26

Maintenance

Maintenance

Changing the Lamp

The projector’s lamp life is approximately 1500 hours of use. The projector automatically monitors the lamp life. After 1500 hours of use, the projector displays the message:

The Lamp has been in use for over 1500 hours. You should purchase a spare bulb.

When you see this message, please contact your local reseller or service center to change the lamp as soon as possible.

Warning—To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if dropped.

Warning—Lamp compartment is hot! Allow the projector to cool down at least 30 minutes.

To change the lamp module

1.Turn off the projector’s power by pressing the power button on the Remote Control or Projector Panel.

2.Disconnect the power cord.

3.Use a screwdriver to remove the two screws from the cover.

Xerox DP1011 User’s Guide

21

Image 26

Contents Xerox DP1011 Projector Page FCC Radio Frequency Interference Statement Table of Contents Welcome Precautions Do’s and Don’ts Don’tWhat’s in the Box Xerox DP1011 Projector Connection Ports Installation Connecting the ProjectorPowering On/Off the Projector To turn on the projector powerTo turn off the projector power To lower the projector Adjusting the Projected ImageTo raise the projector Adjusting the Projector Zoom/Focus Adjusting Projection Image SizePanel Control Panel Control and Remote ControlUser Controls Remote Control On-Screen Display OSD Menus Displaying Menus and Selecting ItemsChoose a Language Adjust the Projector Image Adjust the Computer Image Adjust the Video Image Projector Management Projection DirectionAdjust the PiP Picture in Picture To change the lamp module MaintenanceChanging the Lamp To replace the lamp module, reverse the previous steps Troubleshooting Problem No image appears on the screenIf you are using an Apple PowerBook Problem Image is our of focus Problem The image is flickering or otherwise unstableProblem Image has vertical flickering bar Problem The screen is outstretched when displaying 169 DVDProblem Image is reversed Problem Lamp burns out or make a popping soundXerox DP1011 Projector Specifications Input/Output ConnectorsIf you have an Apple Macintosh Setting the Screen ResolutionIf you have a Windows PC Resolution Analog Compatibility Modes-Windows ComputersResolution Analog Compatibility Modes-Macintosh Computers05-0600-000