UPS Display: Network Configuration Screens
•Apply Changes: Select this button after all changes have been made. All entries will appear in red until Apply Changes is pressed.
•Send Test
SNMP Settings screen
The UPS can be set to send SNMP traps if UPS alarm conditions occur, and when the conditions return to normal afterwards. Each trap contains a description of the alarm condition. Up to 10 Trap Receivers can be entered.
The Trap Receiver must have the APC PowerNet MIB (version 3.6.1 or later). The latest version of the PowerNet MIB can be downloaded from www.apc.com.
Network Settings must be configured prior to configuring the SNMP Settings.
Note
Normal
Network Configuration
5.34 PM
SNMP Settings
Enable SNMP
1 of 10 trap receivers
Trap Receiver(s) | Severity |
xxx.xxx.xxx.xxInformational
Add new
Send Test SNMP
Page 3 of 5
•Enable SNMP: Enable the SNMP functionality by selecting this checkbox.
•To add a new Trap Receiver, touch the Add New button, type in the address and specify the minimum severity of alarm.
•To edit or delete a Trap Receiver, select the recipient as they appear in the recipient list. Choose to either update or delete the Trap receiver.
•Apply Changes: Select this button after all changes have been made. All entries will appear in red until Apply Changes is pressed.
•Send Test SNMP: When this button is pressed, a test trap is sent to all configured Trap Receivers. This button can be used to validate SNMP settings.
Symmetra® MW with Internal Bypass Static Switch - User Guide - | 17 |