Installation & Setup
Attaching Inputs & Outputs
Input and output connectors are the attachment points for source and destination devices that connect to the system. Viewed from the rear of a Precis SD enclosure, the inputs (for sources) are on the left side of the enclosure, and the outputs (for destinations) are on the right side.
The number and type of connectors depend on the signal type and system configuration. Input and output connectors are numbered separately. The connector numbers are either directly above or below the connector (or connector set) and read left to right.
Before connecting all input and output cables/wires, attach only the first two inputs and outputs and execute a test switch (see page 29). When the test switch is successful, attach the rest of the input and output cables and wires.
Video Inputs | Video Outputs |
Audio Inputs | Audio Outputs |
|
FIG. 11 Numbering starts at left for each input & output section
Signal Types & Connectors
The signal types and connectors for an Precis SD system are:
Stereo audio (balanced or unbalanced) over pluggable
For specifications for specific signals, see “Signal Specifications” on page 33.
24 | Precis SD Instruction Manual |