CheetahSwitch Workgroup-4508
Configuring the Serial Port
You can access the
CheetahSwitch Workgroup - 4508
|
| Serial Port Configuration |
|
| |
|
|
| Management Mode | : Console Mode |
|
|
|
| Baudrate | : 19200 |
|
|
|
| Databits | : 8 |
|
|
|
| Stopbits | : 1 |
|
|
|
| Parity | : NONE |
|
|
|
| : 10 |
| |
|
|
| Auto Refresh (in seconds) | : 180 |
|
|
|
|
|
|
|
|
| <APPLY> | <OK> | <CANCEL> |
|
| Use <TAB> or arrow keys to move. <Space> to scroll options. |
| |||
|
|
|
|
|
|
|
|
|
|
| |
Parameter | Default | Description |
|
| |
Management Mode | Console Mode | Indicates if the console port settings are for direct console | |||
|
|
| connection. |
|
|
|
|
| |||
Baud Rate | 19200 | The rate at which data is sent between devices. (Options: | |||
|
|
| 2400, 4800, 9600, 19200, 38400, 57600, 115200 bps, and Auto | ||
|
|
| detection). |
|
|
|
|
| Note that when Auto is selected, you must first press the Enter | ||
|
|
| key once to set the data rate and initialize the connection. | ||
|
|
| |||
Databits | 8 bits | Sets the data bits of the | |||
|
|
| |||
Stopbits | 1 bit | Sets the stop bits of the | |||
|
|
| |||
Parity | none | Sets the parity of the | |||
|
|
| |||
0 minutes | If no input is received from the attached device after this | ||||
|
|
| interval (in minutes), the current session is automatically | ||
|
|
| closed. (Range: 0 | ||
|
|
| |||
Auto Refresh | 0 sec. | Sets the interval before a console session will auto refresh the | |||
|
|
| console information, including Spanning Tree Information, Port | ||
|
|
| Configuration, Port Statistics, and RMON Statistics. | ||
|
|
| (Range: 0, or 5 - 255 seconds; where 0 indicates disabled.) |