CheetahSwitch Workgroup-4508
(c)Copyright 2000, Accton | Inc. | |||
CheetahSwitch | ||||
LOADER | Version | V01.00.01 |
| |
POST | Version | V01.00.01 |
| |
Performing the | ||||
EPROM Checksum | Test | PASS | ||
Testing | the System SDRAM | PASS | ||
CPU Self Test | ............................. | PASS | ||
EEPROM | Checksum | Test | PASS | |
SEEPROM | Checksum | Test | PASS | |
MAC Address |
|
(D)ownload System Image or (S)tart Application: [S]
Select the Firmware Type to Download (1)Runtime (2)POST (3)Mainboard [1]:
For example, if you select 1 (for downloading agent firmware), the system will display the following message:
(D)ownload System Image or (S)tart Application : [S]
Select | the Firmware | Type to Download | (1)Runtim e | (2)POST | ||
(3)Mainboard [1]: 1 |
|
|
|
| ||
Your Selection: Runtime Code |
|
|
| |||
Download code to | FlashROM address 0x02880000 |
|
| |||
Change | Baud Rate | to | 115200 and Press | <ENTER> | t o | Download. |
3.Change your baud rate to 115200 bps, and press Enter to enable download mode. From the terminal emulation program, select the file you want to download, set the protocol to XModem, and then initialize downloading.
Notes: If you use Windows HyperTerminal, disconnect | and reconnect | to |
enable the new baud rate. |
|
|
The download file should be an ES4508 binary file from Accton; otherwise the agent will not accept it. The file naming convention is:
Runtime program:
POST program:
Mainboard program:
4.After the file has been downloaded, the console screen will display information similar to that shown below. Press “s” to start the management interface, change the baudrate back to 19200, and press Enter. The Logon screen will then appear
XModem Download to DRAM buffer area 0x00200000: ... SUCCESS ! Verifying image in DRAM download buffer 0x00200000... SUCCESS ! Update FlashROM Image at 0x02880000 ... SUCCESS !
(D)ownload another Image or (S)tart Application: [S] s Change Baud Rate to 19200 and Press <ENTER>.
For details on managing the switch, refer to Chapter 2 for information on the