Accton Technology CheetahSwitch Workgroup, 4508 manual Displaying the Current Bridge STA

CheetahSwitch Workgroup-4508

Viewing the Current Spanning Tree Configuration

The Spanning Tree Information screen displays a summary of the STA information for the overall bridge or for a specific port. To make any changes to the parameters for the Spanning Tree, use the Spanning Tree Configuration menu. Also note that this screen cannot be accessed unless you have already enabled the Spanning Tree Algorithm via the STA Bridge Configuration menu.

CheetahSwitch Workgroup - 4508

Spanning Tree Information : Selection Menu

STA Bridge Information ...

STA Port Information ...

<OK>

Use <TAB> or arrows keys to move. <Enter> to select.

Displaying the Current Bridge STA

The parameters shown in the following figure and table describe the current Bridge STA Information.

CheetahSwitch Workgroup - 4508

Spanning Tree Information : Bridge STA Information

Priority	: 65535
Hello Time (in seconds)	: 2
Max Age (in seconds)	: 6
Forward Delay (in seconds)	: 5
Hold Time (in seconds)	: 2
Designated Root	: 0.0000e8123456
Root Cost	: 10
Root Port	: 1
Reconfig Counts	: 2
Topology Up Time	: 0 day, 1 hr, 2min, 34 sec
	<OK>
Use <Tab> or arrow keys to move, <Enter> to select.

Parameter	Description
Priority	Device priority is used in selecting the root device, root port, and
	designated port. The device with the highest priority becomes the STA root
	device. However, if all devices have the same priority, the device with the
	lowest MAC address will then become the root device.
Hello Time	The time interval (in seconds) at which the root device transmits a
	configuration message.
Max Age	The maximum time (in seconds) a device can wait without receiving a
	configuration message before attempting to reconfigure.
Forward Delay	The maximum time (in seconds) the root device will wait before changing
	states (i.e., listening to learning to forwarding).

2-20