CheetahSwitch Workgroup-4508
Parameter | Description |
|
Type | Shows port type as 1000SX | |
Status | Displays the current state of this port within the spanning tree: | |
| Disabled | Port has been disabled by the user or has failed diagnostics. |
| Blocked | Port receives STA configuration messages, but does not |
|
| forward packets. |
| Listening | Port will leave blocking state due to topology change, starts |
|
| transmitting configuration messages, but does not yet |
|
| forward packets. |
| Learning | Has transmitted configuration messages for an interval set by |
|
| the Forward Delay parameter without receiving contradictory |
|
| information. Port address table is cleared, and the port |
|
| begins learning addresses. |
| Forwarding | The port forwards packets, and continues learning addresses. |
| The rules defining port status are: | |
| • A port on a network segment with no other STA compliant bridging | |
| device is always forwarding. | |
| • If two ports of a switch are connected to the same segment and there is | |
| no other STA device attached to this segment, the port with the smaller | |
| ID forwards packets and the other is blocked. | |
| • All ports are blocked when the switch is booted, then some of them | |
| change state to listening, to learning, and then to forwarding. | |
Designated Cost | The cost for a packet to travel from this port to the root in the current | |
| spanning tree configuration. The slower the media, the higher the cost. | |
Designated Bridge (ID) | The priority and MAC address of the device through which this port must | |
| communicate to reach the root of the spanning tree. | |
Designated Port (ID) | The port on the designated bridging device through which this switch must | |
| communicate with the root of the spanning tree. |