Paxar 611, 610, 612 user manual Audience, Unpacking the Printer, Connecting the Power Cable

Page 6

Audience

The Operator's Handbook is for the person who prints and applies labels.

Unpacking the Printer

After you unpack the printer, you should have: a 610 / 611 / 612 printer, power cord, communication cable and a ribbon take-up core (may already be on take-up reel).

Keep the box and packaging material in case the printer ever needs repair.

Power cords are not supplied with 230-volt printers. You need to purchase a power cord separately. The power cord requires IEC 320 STD C13 end finish for the printer interface and it must meet requirements for 1.6 Amps at 115VAC and 1 Amp at 230VAC.

Connecting the Power Cable

To connect the power cable:

1.Plug the power cable into the socket. Plug the other end of the cable into a grounded electrical outlet.

2.Turn on the printer. Press ( I ) to turn on and ( O ) to turn off the printer.

Power Cable goes here

For information about replacing the fuse, see Chapter 4, "Care and Maintenance."

2 ∙ Getting Started

Users Manual - 610/611/612 Printers

Image 6

Contents 610 / 611 / 612 Printers Paxar Systems Group Manual Edition MarchThis page left blank intentionally Contents Troubleshooting Appendix a Specifications & AccessoriesContacting Paxar Getting Started Connecting the Power Cable AudienceUnpacking the Printer Connecting the Communication Cable Default Serial Port Communication ValuesEstablishing Communications Default Printer Settings Using the Control PanelPrinter Status Lights Button Functions Status Code BoxSetting Dip Switches DIP Switches Feed Mode Lower DIP Switches Flow ControlDiagnostics VerifierLoading Supplies Loading Labels 610 Do not pick up the printer By the supply holder Peel Bar Ribbon Bar Loading Supplies ∙ 14 ∙ Loading Supplies Loading Labels 16 ∙ Loading Supplies Loading Supplies ∙ 18 ∙ Loading Supplies Loading Supplies ∙ Loading Ribbon Loading Supplies ∙ Take-up Reel Back Reel Loading Supplies ∙ Adjusting the Wide/Narrow Knobs Loading Supplies ∙ Printing PrintingPrinting an Error Label Printer Alignment Top and Bottom CopyNon-Printing Zone Preventing JamsAdjusting Print Positions Printing Serial Bar CodesPrint Position Adjusting the Cut AngleSupply Position Margin PositionUsing the Knife Adjusting the Drop TrayCare Symbol Font Samples Ginetex FontNafta Font Care and Maintenance Clearing Supply Jams Clearing a Knife JamCleaning 36 ∙ Care and Maintenance Replacing the Printhead 38 ∙ Care and Maintenance Care and Maintenance ∙ Snap the printhead into place Adjusting the Print Contrast Replacing the Fuse Lubricating the Knife Troubleshooting Printing a Test Label Troubleshooting Problem ActionError Messages Data ErrorsOption number must be 1, 4, 30, 31, 42, 50, 60, or Troubleshooting ∙ 50 ∙ Troubleshooting Troubleshooting ∙ Error Description/Action Communication FailuresData Formatting Errors Machine Faults Troubleshooting ∙ Appendix a Specifications & Accessories Printer SpecificationsSupply Specifications Paxar SystemsRibbon Specifications Ribbon WidthsAccessories Contacting Paxar