Rose electronic 2xE manual Two expansion cards are, Installed in the 4xE model, RS232 port

The 4xE model can have two expansion cards installed. The bottom expansion card transmits the signals for KVM 1 and 2; the top expansion card transmits the signals for KVM 3 and 4. If an expansion card is permanently removed, a terminator and cover plate must be installed.

IN	JP1
OUT	Two expansion cards are
	installed in the 4xE model

Figure 2. Expansion card

To remove the expansion card and install/remove jumper JP1:

1.Remove power from the UltraMatrix switch.

2.Remove any expansion cables.

3.Unscrew the two screws securing the expansion card to the chassis. (Bottom expansion card only on a 4xE model)

4.Carefully pull the expansion card straight back until it unseats from the backplane connector.

5.Remove/install the jumper JP1, on the expansion cards.

6.Re-install the expansion card. Make sure it seats properly in the backplane connector.

7.Secure the expansion card with the two screws.

8.Replace any expansion cables

RS232 port

All UltraMatrix switches are equipped with an RS232 serial port on each installed CPU slot. These ports on all UltraMatrix models are RJ12, 6-conductor connectors. They provide a serial interface to the UltraMatrix from a computer terminal, a standalone computer or a Notebook computer that is not connected to a CPU port on the Unit. The RS232 serial port enables you to:

„Upgrade the system firmware

„Restore a Unit to its factory default settings

„Configure an expansion switch

„Switch a KVM station to a CPU port

An adapter and serial cable are provided for serial interface. Firmware cannot be updated from a computer terminal.

8ULTRAMATRIX E-SERIES MANUAL