Rose electronic 2xE manual Message Description, Kernel halt error messages

Kernel halt error messages

Message	Description
BAD Address = nn	Kernel memory is corrupt, hardware failure.
Resetting to factory	A memory error is detected during a read
defaults	from configuration memory. This also
	indicates a hardware failure, but the system
	may continue to initialize successfully. The
	configuration from another Unit should be
	saved to this Unit as soon as possible.
Unit Halted	A major error has forced the kernel to stop
	processing. The UltraMatrix waits to receive a
	kernel or main firmware file from the bottom
	board’s serial port using the serial
	parameters: 9600, N, 8, 1. Connect the serial
	cable supplied with the UltraMatrix as
	described in the Serial Port section, start a
	terminal emulator and transfer the file using
	an ASCII file transfer protocol.
Kernel is bad, load	The UltraMatrix waits to receive a kernel or
new kernel through	main firmware file from the bottom board’s
serial port.	serial port using the serial parameters: 9600,
	N, 8, 1. Connect the serial cable supplied
	with the UltraMatrix as described in the Serial
	Port Section, start a terminal emulator and
	transfer the file using an ASCII file transfer
	protocol.
Checksum error	The kernel writes this message at power up
	when a memory error is detected during a
	read from program memory.

ULTRAMATRIX E-SERIES MANUAL

73