Click “OK” when all values have been entered. The HyperTerminal dialog box will display and information can be exchanged with the UltraMatrix switch properly. You can save this setup so the next time its needed, you can select the ICON with the name you gave it and these settings will already be established.
Starting a serial communication session
Verify that “Connected” appears in the bottom left corner of the HyperTerminal window. If “Connected” is not present, click on the “Call” icon. “Connected” should display in the bottom left corner.
Power on or cycle power on the UltraMatrix switch and press the spacebar when the message, “Hit the spacebar within 5 seconds to get serial options menu” appears on your screen. The serial menu will appear after the diagnostic check completes. If unrecognizable characters appear, the baud rate set on the UltraMatrix switches serial port and the baud rate set on your computers COM port are not set to the same value. Disconnect from the UltraMatrix by clicking on the “Disconnect” ICON. Change the baud rate on your terminal or computers communication program from 9600 (set previously) to 57,600.
UM - HyperTerminal
File Edit View Call Transfer Help
Serial options menu
1)Change starting computer number … 1
2) Change the serial port baud rate … 9600
3)Receive new main program or kernel from serial port (this card only)
4)Send this unit’s main program to other units
5)Send this unit’s kernel to other units
6)Reset configuration data to factory defaults (this card only)
7)Save changes made in 1 and 2 (this card only)
8)Exit (restart the unit)
Enter choice - - >
Connected 0:03:00 Auto detect 9600