Rose electronic 2xE manual Operation, User operating instructions, Keyboard commands

OPERATION

User operating instructions

The following instructions apply to all UltraMatrix switches.

This section explains the operating functions of the on-screen displays, the login procedure, connect procedure and other commands needed to easily use the UltraMatrix switch and its capabilities.

To start using your UltraMatrix switch, you first need to become familiar with the keyboard commands. The available keyboard commands are shown in Table 1. All keyboard commands start with an attention sequence by pressing and releasing the left [Ctrl] key, then the additional command characters. The additional command characters must be entered within two seconds of each other or the command is aborted.

Commands are not case sensitive and are shown in upper or lower case for clarity only. Do not use the [SHIFT] key or the numeric keypad to enter any commands. [Ctrl] in Table 1’s, Key Sequence column is a press and release function of the left [Ctrl] key.

Keyboard commands

Command	Key Sequence		Description
Main Menu	[Ctrl]	[F12]	Displays main menu
CPU List	[Ctrl]	[Esc]	Displays CPU selection list
Direct CPU	[Ctrl]	n [Enter]	Connects directly to the specific
connect			CPU number “n”.
Connect Back	[Ctrl]	[Backspace]	Connects to the previous CPU
Connect Down	[Ctrl]	[Minus sign]	Connects to the previous CPU
			in a Group.
Connect Up	[Ctrl]	[Plus sign]	Connects to the next sequential
			CPU in a group
KVM Status	[Ctrl]	D	Displays / Removes status box.
Logout	[Ctrl] L		Logs user out if the KVM station
			is configured for user logins.
Disconnect	[Ctrl] Q		Disconnects the current CPU
Reset	[Ctrl] R		Resets / enables keyboard and
Keyboard/			mouse; enables PS/2 mouse on
mouse			connected CPU

ULTRAMATRIX E-SERIES MANUAL

45