SUPER MICRO Computer C2SEE, C2SEA user manual XAdvanced Chipset Settings, XNorthBridge Configuration

C2SEA/C2SEE User’s Manual

XAdvanced Chipset Settings

The items included in the Advanced Settings submenu are listed below:

XNorthBridge Configuration

This feature allows the user to configure the settings for the Intel 945GME NorthBridge chipset.

Memory Remap Feature

PCI memory resources will overlap with the total physical memory if 4GB of memory or above is installed on the motherboard. When this occurs, Enable this function to reallocate the overlapped physical memory to a location above the total physical memory to resolve the memory overlapping situation.The options are Enabled and Disabled.

PCI MMIO Allocation

Use this feature to assign the address for PCI Memory-mapped IO (MMIO) allocation. The Default setting is 4 GB to 3072 MB.

DRAM Frequency

This feature allows the user to select the DRAM Frequency setting. The options are Auto (Auto-detect), 533 MHz, 667 MHz, 800 MHz, and 1067 MHz.

Configuring DRAM Timing by SPD

Select Enable to allow the BIOS to read the SPD (Serial Presence Detect) chip which is built in the memory module in order to get the exact memory specifica- tions. The options are Enabled and Disabled.

Memory Hole

Use the feature to allocate memory resource reserved for use of PCI devices. If set to 15 MB~16MB, the reserved memory will be placed in the location around 15 MB~16 MB. The options are Disabled and 15 MB~ 16 MB.

Initiate Graphic Adapter

Use the feature to select the graphics controller to be used as the primary boot device. The options are IGD, PCI/IGD, PCI/PEG, PEG/IGD, and PEG/PCI.

IGD Graphics Mode Select

Use the feature to set the amount of system memory to be used by the Internal Graphics Devices. The options are Disabled, Enabled 32 MB, Enabled 64 MB, and Enabled 128 MB.

4-8