SMC Networks EX500-GEN1 instruction manual Reduced wiring system

Page 1

Reduced wiring system

EtherNet/IP™ Compatible GW Unit

Instruction Manual

EX500-GEN1

URL http:// www.smcworld.com

Specifications are subject to change without prior notice and any obligation on the part of the manufacturer. EtherNet/IP™ is a trademark used under licence by ODVA.

The descriptions of products shown in this document may be used by the other companies as their trademarks. © 2006 SMC Corporation All Rights Reserved

Image 1
Contents Reduced wiring system Contents Otherwise injury or failure can result Do not operate beyond specification rangeOtherwise accident caused by malfunction can result Otherwise injury can resultSystem configuration general SafetyProduct Summary Manifold valve with SI unit SV/VQC seriesInstallation unit mm Dimensions unit mmEX500 Part Names EX500 bodyBasic specifications SpecificationHigher-level bus MappingSpecification WiringWirings is explained in the following order Lower-level busCommunication wiring WiringPower supply wiring Cable connectionSingle power supplies Branch wiringCable plug For GW unit Input unit manifold configuration For GW unit Manifold valve Input unit manifold configurationSwitch setting Display/Switch SettingDisplay Default settings Display/Switch SettingSI Unit Part Names SI unit for SV series valves EX500-SEX500-Q Mounting/WiringMounting and removing methods of SI unit are as shown below SI unit for SV series valve EX500-S DisplaySI unit for VQC series valve EX500-Q Applicable valve seriesInput Unit Manifold Part Names When only input blocks for M8 connector are connectedDimensions unit mm InstallationWhen only input blocks for M12 connector are connected Specifications for Input unitLights off Sensor signal input OFF logical Sensor wiringCorrespondence between input number and input block Connect sensors to the sensorEX9-OET1/EX9-OET2 EX9-PE1 EX9-PE1Part name Application EX9-OEP1/EX9-OEP2 output connectors Output wiringDimensions when general purpose output block is connected MountingEX9-PE1 power input connector No.1 EX9-PE1 power supply connector No.0PWR EX9-OET1 EX9-OET2 EX9-OEP1 EX9-OEP2Option Overall system TroubleshootingEtherNet/IP compatible communication COM a D LED