SMC Networks EX500-GEN1 For GW unit Manifold valve Input unit manifold configuration

Page 10

Wiring (continued )

For GW unit – Manifold valve – Input unit manifold configuration

Two communication connectors in SI unit and one communication connector in Input unit are installed respectively.

To the communication connector ( C2 ) or ( 1 ) of SI unit, connect the branch cable with M12 connector from GW. To the communication connector ( C1 ) or ( 0 ), connect the branch cable with M12 connector from Input unit.

To the communication connector of Input unit, connect the branch cable with M12 connector from SI unit.

GW unit

Manifold valve with SI unit ( for SV/VQC series )

Connector ( C1 ) / ( 0 )

Connector ( C2 ) / ( 1 )

Branch cable

with M12 connector

Input unit manifold

NOTE

Manifold valve with SI unit

When no Input unit is connected( for SV/VQC series ) to the connector ( C1 ) or ( 0 ) of

SI unit, mount a terminal plug on the connector.

Terminal plug

For GW unit – Input unit manifold configuration

To the communication connector of Input unit, connect the branch cable with M12 connector from GW unit.

GW unit

Branch cable

Input unit manifold

with M12 connector

 

Type, pin layout and connection diagram of the branch cable with M12 connector ( EX500-AC - )

 

L

48

52

M12

6

 

16

14.9

M12

 

 

Straight Connector Type

 

EX500-AC -SSPS

M12

M12

 

 

6

28.3

32.3

31.3

31.3

 

L

Angle Connector Type

EX500-AC-SAPA

L = 300, 500, 1000, 3000, 5000 ( mm )

16

17

Image 10
Contents Reduced wiring system Contents Otherwise accident caused by malfunction can result Do not operate beyond specification rangeOtherwise injury or failure can result Otherwise injury can resultProduct Summary SafetySystem configuration general Manifold valve with SI unit SV/VQC seriesEX500 Part Names Dimensions unit mmInstallation unit mm EX500 bodyHigher-level bus SpecificationBasic specifications MappingWirings is explained in the following order WiringSpecification Lower-level busPower supply wiring WiringCommunication wiring Cable connectionSingle power supplies Branch wiringCable plug For GW unit Manifold valve Input unit manifold configuration For GW unit Input unit manifold configurationSwitch setting Display/Switch SettingDisplay SI Unit Part Names Display/Switch SettingDefault settings SI unit for SV series valves EX500-SEX500-Q Mounting/WiringMounting and removing methods of SI unit are as shown below SI unit for VQC series valve EX500-Q DisplaySI unit for SV series valve EX500-S Applicable valve seriesWhen only input blocks for M8 connector are connected Input Unit Manifold Part NamesWhen only input blocks for M12 connector are connected InstallationDimensions unit mm Specifications for Input unitCorrespondence between input number and input block Sensor wiringLights off Sensor signal input OFF logical Connect sensors to the sensorEX9-OET1/EX9-OET2 EX9-PE1 EX9-PE1Part name Application Dimensions when general purpose output block is connected Output wiringEX9-OEP1/EX9-OEP2 output connectors MountingEX9-PE1 power supply connector No.0 EX9-PE1 power input connector No.1EX9-OET1 EX9-OET2 EX9-OEP1 EX9-OEP2 PWROption EtherNet/IP compatible communication TroubleshootingOverall system COM a D LED