SMC Networks SMCBR24Q user manual When Fail

Page 78

SMCBR24Q User Manual

Retry timeout: The interval between two ping actions. The default is 30 seconds.

When Fail:

Generate the Error Condition in the System Log: The Router will generate the System Log when ping fails to inform users that the ISP connection is disconnected.

Remove the Connection: This WAN Interface will be suspended when the network connection to ISP is not active. The traffic on this WAN will be dispatched to the other WAN port. Once connection to ISP is re-established, the traffic will be dispatched back.

If you enable NSD, you have to choose at least one option from the following four items. Default Gateway: If you check this item, the Router will ping the default gateway first.

ISP Host: After pinging Default Gateway, the Router will ping ISP Host “Retry timeout” later. The ISP Host is provided by ISP.

Remote Host: Enter the IP address of Remote Host that you’re going to ping.

DNS Lookup Host: Enter the Host Name or Domain Name that you’re going to ping.

Page 78

Image 78

Contents Page Table of Contents Dhcp Introduction Main features LED Status Feature ListReset Button ButtonLogin ModeSite Map System Summary System InformationUser Usage User BandwidthISP Bandwidth Basic Setup NetworkObtain an IP automatically Static IPEnter your Username and Password Password Old Password New PasswordConfirm New Password Time AutomaticallyManual MAC Clone Page Remote Internet Passport On-Line SchedulerWeb Site Hit Rate Application Usage Page Performance Optimization Please refer to Q-button-Home Mode To create a new application Block List Web Site Block ListApplication Block List Advanced Setup DMZ HostForwarding Port Range ForwardingPort Triggering UPnP Ddns Advanced Routing Dynamic Routing Static RoutingVPN Pass Through Pptp Pass Through Remote ManagementIPSec Pass Through L2TP Pass ThroughDiagnostics System ManagementDNS Name Lookup Factory Default PingFirmware Upgrade Import Configuration FileExport Configuration File LogSyslog When system alert, send log immediatelyThere are four buttons follow the setup section MailPage Button in the Home Mode Button, Q-button LED and Q-button iconPage How to Manage SMCBR24Q Soho Mode Site Map System up time ConfigurationSerial Number Firmware versionNetwork Setting Status Firewall Setting Status Log Setting StatusSetup NetworkWAN Connection Type Enter your Username and Password Re-enter the password for confirmation Administrator Inactivity Time-out DMZ Host Forwarding Port Range Forwarding Port Triggering UPnP Ddns Advanced Routing Dynamic Routing Page Setup DhcpPage Dynamic IP Wins ServerSecurity StatusSPI Stateful Packet Inspection DoS Denial of ServiceFirewall Block WAN RequestMulticast Pass Through Access RulesRemote Management MTU Maximum Transmission UnitAdd a new Policy Services ServiceAction Destination IP SchedulingSource IP Apply this rule time parameterContent Filter Forbidden DomainsOn the Forbidden Domains list Scheduling Apply this ruleVPN Pass Through System Management Network Service DetectionWhen Fail Dual WANNetwork Service Detection When Fail Bandwidth Protocol BindingQoS Rate ControlRate Control Priority SummaryDiagnostic DNS Name Lookup Page Factory Default Firmware Upgrade Firmware DownloadSetting Backup System Log Log Setting Alert LogGeneral Log Page System Statistics Button in the Soho Mode If no configuration in the QoS page by the UIIf any configuration in the QoS page by the UI