Western Telematic manual NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide

Page 14

NPS-2HDHeavyDutyNetworkPowerSwitch;User'sGuide

8.Test Boot Commands: When the NPS-2HD is powered up, both switched plugs will be set in the ON position. In order to test for proper operation, you may wish to perform the following test. Note that it is not necessary to connect a device to either switched outlet in order to perform

this test.

a)Reboot Plugs: To initiate a boot cycle at both plugs, go to the NPS command prompt and type /BOOT * and press [Enter]. Power to both plugs will be switched OFF. After the Boot Delay Period (Default = 5 Seconds), the power to both plugs will then be automatically switched back ON. Note that the Plug Status Indicators on the NPS-2HD front panel will also switch Off and On.

b)Switch Plugs OFF: To switch both plugs OFF, go to the NPS command prompt, type /OFF * and then press [Enter]. Power to both plugs will be switched OFF. Note that the Plug Status Indicators will also be switched Off.

c)Switch Plugs ON: To switch both plugs ON, go to the NPS command prompt, type /ON * and then press [Enter]. Power to both plugs will be switched ON. Note that the Plug Status Indicators will also be switched On.

9.Exit Command Mode: Type /X and press [Enter] to exit from the NPS Command Mode, or disconnect using your Telnet program.

This completes the introductory overview of the NPS-2HD. Prior to installing and operating the unit, please review the remainder of this User's Guide for important information regarding safety considerations, as well as more detailed installation, configuration, and operation instructions.

3-4

Page 13 Page 15
Image 14
Page 13 Page 15
Contents NPS-2HD Page Nameplate Power Warning Rack Mount InstallationDisconnect Power VentilationNetwokCable OptionSwichesCable SystemModeOnly Intelligent Power Control IntroductionTypographic Conventions Unit Description Front PanelBack Panel Circuit Breaker 115 VAC, 20 AmpsQuick Start Guide Page QuickStartGuide NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Cable Clamp Installation InstallationPower Connection 1OutputCableClampInstallation Output Cable ClampInstallation Input Cable ClampOption Switches Disconnect TimeoutDefault Parameters Option Reset Unit to DefaultsDefault Button / Reset Button Local Console Port Connection Connecting an External ModemConnecting the Network Cable Configuration System Mode and User ModeCommunicating with the NPS =AllPlugswithAccess NPS Command/Menu Conventions Defining General ParametersButtonMode NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Configuration Plug ParametersPage 00-40-05-5e-f3-90 Network ParametersImplementing IP Security Configuration Save Configuration Parameters Access the NPS-2HD Command Mode OperationMrmaio Displaying Plug StatusBoot/On/Off Commands OperationOFF POWER2 or /OF POWER2 and press Enter Default Command Automated ModeNPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Reset Network Port Other CommandsLogin as Different User Exit / DisconnectManual Operation Operating TipsSaving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Interface Descriptions Console Port InterfaceApx-2 Modem Port InterfaceSpecifications Input Connector IEC-320-C19 InletCustomer Service Apx-4Appendices Trademark and Copyright InformationApx-6 4-6 FrontactoryPanSttigsAddresslIndicators.FIndex 4-6,6-8 OnsolePortA58,643 PowerInletNameOwnrship
Top Page Image Contents