NPS-2HDHeavyDutyNetworkPowerSwitch;User'sGuide
6.7. Manual Operation
In addition to the command driven functions, the NPS's two switched plugs can also be toggled On and Off manually. To manually toggle a plug On or Off, press the appropriate Manual Control Button, and hold it down for approximately one second; the corresponding plug will be toggled On or Off. Note that if desired, the Manual Control Buttons can also be disabled via the General Parameters menu as described in Section 5.4.
6.8. Operating Tips
When connecting to the
1.One Connection at a Time: Only one port can access the command mode at a time. Therefore, it is recommended that users should always disconnect using the /X command when finished communicating with the unit. When a command port is busy, the
a)Network Port Busy: If a second user attempts to connect via the Modem Port, the NPS will send a busy message. If a second user attempts to connect via the Console Port, the port will not wake.
b)Modem Port Busy: If a second user attempts to connect via the Network Port, the connection will be refused. If a second user attempts to connect via the Console Port, the port will not wake.
c)Console Port Busy: If a second user attempts to connect via the Network Port, the connection will be refused. If a second user attempts to connect via the Modem Port, the Console Port will disconnect and the Modem Port will be granted access; the Modem Port has priority over the Console Port.
2.Ping Packet Size: The NPS will not accept Ping Packets larger than approximately 1000 bytes.
If you have any questions regarding configuration or operation of the NPS, please contact WTI Technical Support as described in