Western Telematic NPS-2HD manual

Page 28

NPSFigure43BotDelay:21PLUGEnter.-2HDPo#15assword:lugSelection.4:HeavyPARAMETERS:Name:PlugUpDefault:DutyParametersorNetwork<ESC>On5Power(undefined)toMenuSecExitSwitch;(Plug...User's1Shown)Guide

2.Password: (Up to 16 Characters) Assigns a User Password to this plug. When a User Password is assigned, the plug is then "owned" by that password. When a User Password is entered at login, the user will have access to only the plug(s) which are owned by this password. (Default = undefined).

Notes:

￿If you wish to allow a single user to access both switched plugs, assign the same User Password to both plugs.

￿If the System Password is defined, and the plug's User Password is not defined, then the System Password will "own" this plug, and only the System Mode will be able to control the plug.

3.Boot Delay: During a Boot cycle, power to the plug is first switched off and then switched back on. The Boot Delay is the length of time which elapses between the time when power is switched off and the time that power is restored. The Boot Delay can be 1, 5, 10, 15, 30 or 60 seconds. (Default determined by Option Switch 2; Factory Setting = 5 Seconds).

4.Power-Up Default: Determines how this plug will react when the /D (default) command is invoked, or after a power interruption. Each plug can be automatically switched On or Off as specified by the Power-Up Default. (Default = On).

After Plug Parameters have been defined, press [Esc] to exit 5-8from the Plug Parameters menu.

Page 27 Page 29
Image 28
Page 27 Page 29
Contents NPS-2HD Page Nameplate Power Warning Rack Mount InstallationDisconnect Power VentilationCable OptionSwichesNetwokCable SystemModeOnly Intelligent Power Control IntroductionTypographic Conventions Unit Description Front PanelBack Panel Circuit Breaker 115 VAC, 20 AmpsQuick Start Guide Page QuickStartGuide NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Power Connection InstallationCable Clamp Installation 1OutputCableClampInstallation Output Cable ClampInstallation Input Cable ClampOption Switches Disconnect TimeoutDefault Button / Reset Button Local Reset Unit to DefaultsDefault Parameters Option Connecting the Network Cable Connecting an External ModemConsole Port Connection Configuration System Mode and User ModeCommunicating with the NPS =AllPlugswithAccess NPS Command/Menu Conventions Defining General ParametersButtonMode NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Configuration Plug ParametersPage 00-40-05-5e-f3-90 Network ParametersImplementing IP Security Configuration Save Configuration Parameters Access the NPS-2HD Command Mode OperationMrmaio Displaying Plug StatusBoot/On/Off Commands OperationOFF POWER2 or /OF POWER2 and press Enter Default Command Automated ModeNPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Other Commands Login as Different UserReset Network Port Exit / DisconnectManual Operation Operating TipsSaving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Interface Descriptions Console Port InterfaceApx-2 Modem Port InterfaceSpecifications Input Connector IEC-320-C19 InletCustomer Service Apx-4Appendices Trademark and Copyright InformationApx-6 FrontactoryPanSttigsAddresslIndicators.F Index4-6 4-6,6-8 OnsolePortANameOwnrship PowerInlet58,643
Top Page Image Contents