Western Telematic NPS-2HD manual 00-40-05-5e-f3-90, Network Parameters

Page 29

3Gateway2Subnet1NETWORKAddress:PARAMETERS:Mask:Address:(undefined)

Configuration

MAC4.

Address:IPSecurity

00-40-05-5e-f3-90

 

Figure5EnterSelection.5:NetworkParameters<ESC>toExitMenu...(SystemModeOnly)

 

5.6. Network Parameters

In order to communicate with the NPS-2HD via network, the IP Address, Subnet Mask and Gateway Address must first be defined using the Network Parameters menu. If desired, this menu also allows you to implement IP Security features, which restrict command mode access based on the user's IP Address.

Settings for network parameters depend upon the configuration of your individual network. Please contact your network administrator for appropriate settings, and then assign parameters as described in this section.

To access the Network Parameters menu (Figure 5.5), type /N and press [Enter]. Note that this menu is not available in User Mode. The following options are available:

1.IP Address: Defines the IP Address for the NPS unit. Type 1 press [Enter], and follow the instructions in the submenu. (Default = undefined)

2.Subnet Mask: Defines the Subnet Mask for the NPS unit. Type 2 press [Enter], and follow the instructions in the submenu. (Default = undefined)

3.Gateway Address: Defines the Gateway Address for the NPS unit. Type 3 press [Enter], and follow the instructions in the submenu. (Default = undefined)

4.IP Security: Sets up the IP Security feature as described in Section 5.6.1.

5.Mac Address: Displays the unit's MAC Address. Note that this item is not used to redefine the MAC Address. 5-9

Page 28 Page 30
Image 29
Page 28 Page 30
Contents NPS-2HD Page Rack Mount Installation Nameplate Power WarningVentilation Disconnect PowerNetwokCable OptionSwichesCable SystemModeOnly Introduction Intelligent Power ControlTypographic Conventions Front Panel Unit DescriptionCircuit Breaker 115 VAC, 20 Amps Back PanelQuick Start Guide Page QuickStartGuide NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Cable Clamp Installation InstallationPower Connection Output Cable Clamp 1OutputCableClampInstallationInput Cable Clamp InstallationDisconnect Timeout Option SwitchesDefault Parameters Option Reset Unit to DefaultsDefault Button / Reset Button Local Console Port Connection Connecting an External ModemConnecting the Network Cable System Mode and User Mode ConfigurationCommunicating with the NPS =AllPlugswithAccess Defining General Parameters NPS Command/Menu ConventionsButtonMode NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Plug Parameters ConfigurationPage Network Parameters 00-40-05-5e-f3-90Implementing IP Security Configuration Save Configuration Parameters Operation Access the NPS-2HD Command ModeDisplaying Plug Status MrmaioOperation Boot/On/Off CommandsOFF POWER2 or /OF POWER2 and press Enter Automated Mode Default CommandNPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Login as Different User Other CommandsReset Network Port Exit / DisconnectOperating Tips Manual OperationSending Parameters to a File Saving and Restoring Configuration ParametersRestoring Saved Parameters Console Port Interface Interface DescriptionsModem Port Interface Apx-2Input Connector IEC-320-C19 Inlet SpecificationsApx-4 Customer ServiceTrademark and Copyright Information AppendicesApx-6 Index FrontactoryPanSttigsAddresslIndicators.F4-6 4-6,6-8 OnsolePortA58,643 PowerInletNameOwnrship
Top Page Image Contents