Western Telematic NPS-2HD manual 1OutputCableClampInstallation, Output Cable Clamp

NPS-2HDHeavyDutyNetworkPowerSwitch;User'sGuide

Figure4.1:OutputCableClampInstallation

4.1.2.Output Cable Clamp

1.Loosen Screws: Locate the two screws which secure each output jack to the NPS-2HD back panel. Carefully loosen each screw to provide sufficient room for the cable clamp to be attached after it is fitted to the cable.

Note: Make certain to loosen the screws enough to allow the cable clamp to be installed, but do not entirely remove the screws from the NPS

back panel.

2.Connect Plug: Plug the power cable from your AC powered device into the output jack. Make certain that the plug is firmly seated. Note that the total load for each outlet must not exceed 20 amps.

3.Fit Clamp to Plug: Carefully slip the output cable clamp (See Figure 4.1) over the output plug, making certain that the two slots at the base of the clamp are properly seated over the screws which secure the output jack to the back panel. The U-shaped cutout, located at the back of the clamp, should face downwards in order to allow the clamp to fit over the cable.

4.Tighten Screws: Tighten the screws which secure the

4-2output cable clamp to the output jack.