Western Telematic NPS-2HD manual Restoring Saved Parameters

Page 42

NPS-2HDHeavyDutyNetworkPowerSwitch;User'sGuide

7.2. Restoring Saved Parameters

This section describes the procedure for using ProComm to send saved parameters to the NPS-2HD.

1.Start your communications program and access the NPS command mode using the System Level Password.

2.Configure your communications program to upload an ASCII text file.

3.Upload the file with the saved parameters. If necessary, key in the file name and directory path.

4.When the upload is complete, make certain to terminate the communications program's upload mode.

Note:

The current On/Off status of each NPS-2HD plug will not be saved or restored. However, the selected default On/Off setting for each plug will be saved and restored.

When the configuration file is sent to the NPS-2HD via telnet, the unit's IP Address, Subnet Mask, and Gateway Address cannot be altered.

5.Type /SP and press [Enter], the NPS-2HD will display the Status Screen with passwords revealed. Check the Status Screen to make certain that saved parameters have been restored.

7-2

Image 42

Contents NPS-2HD Page Nameplate Power Warning Rack Mount InstallationDisconnect Power VentilationOptionSwiches CableNetwokCable SystemModeOnly Intelligent Power Control IntroductionTypographic Conventions Unit Description Front PanelBack Panel Circuit Breaker 115 VAC, 20 AmpsQuick Start Guide Page QuickStartGuide NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Installation Power ConnectionCable Clamp Installation 1OutputCableClampInstallation Output Cable ClampInstallation Input Cable ClampOption Switches Disconnect TimeoutReset Unit to Defaults Default Button / Reset Button LocalDefault Parameters Option Connecting an External Modem Connecting the Network CableConsole Port Connection Configuration System Mode and User ModeCommunicating with the NPS =AllPlugswithAccess NPS Command/Menu Conventions Defining General ParametersButtonMode NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Configuration Plug ParametersPage 00-40-05-5e-f3-90 Network ParametersImplementing IP Security Configuration Save Configuration Parameters Access the NPS-2HD Command Mode OperationMrmaio Displaying Plug StatusBoot/On/Off Commands OperationOFF POWER2 or /OF POWER2 and press Enter Default Command Automated ModeNPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Reset Network Port Other CommandsLogin as Different User Exit / DisconnectManual Operation Operating TipsSaving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Interface Descriptions Console Port InterfaceApx-2 Modem Port InterfaceSpecifications Input Connector IEC-320-C19 InletCustomer Service Apx-4Appendices Trademark and Copyright InformationApx-6 4-6 FrontactoryPanSttigsAddresslIndicators.FIndex 4-6,6-8 OnsolePortAPowerInlet NameOwnrship58,643