Operation
6.6. Other Commands
6.6.1.Login as Different User
The /R command is used to
The /R command is available in both System Mode and User Mode. To login as a different user, type /R, press [Enter], and then key in a different valid password at the prompt. To suppress the "Sure?" prompt, type /R,Y [Enter].
6.6.2.Reset Network Port
The /T command is used to reinitialize the NPS Network card. The /T command is not available in User Mode. To reset the Network Port, type /T and press [Enter]. To suppress the "Sure?" prompt, type /T,Y [Enter].
Note: The /T command can only be issued via the Console Port or Modem Port. The /T command cannot be invoked via the Network Port.
6.6.3.Exit / Disconnect
To exit from the NPS Command Mode and discontinue connection to the unit, type /X and press [Enter]. The NPS will display the "DISCONNECT" message. To suppress the "Sure?" prompt, type /X,Y [Enter].
Note: Only one port may access the NPS command |
|
mode at any given time. In order to allow access to |
|
the NPS unit via other ports, always exit from the |
|
command mode when you are finished |
|
communicating with the unit. For more information, |
|
please refer to Section 6.8. |