Western Telematic NPS-2HD manual Installation, Input Cable Clamp

Page 17

Installation

Figure4.2:InputCableClampInstallation

4.1.3.Input Cable Clamp

1. Loosen Screws: Locate the two screws which secure each input jack to the NPS-2HD back panel. Carefull loosen each screw to provide sufficient room for the input jack clamp to be attached.

Note: Make certain to loosen the screws enough to allow the clamp to be installed, but do not entirely remove the screws from the NPS back panel.

2. Attach Clamp to Jack: Slip the input clamp into place, making certain that the screw slots in the base of the clamp are securely seated over the screws which secure the input jack to the back panel. Make certain to position the clamp so the retaining screw (see Figure 4.2) is facing upwards. Tighten the screws to secure the clamp to the input jack.

3. Connect Plug: Slide the input plug into the cable clamp. If necessary, loosen the retaining screw to provide room for the plug. Make certain that the plug is firmly seated in the jack, and then tighten the retaining screw to secure the

clamp to the cable.

4-3

Image 17

Contents NPS-2HD Page Rack Mount Installation Nameplate Power WarningVentilation Disconnect PowerNetwokCable OptionSwichesCable SystemModeOnly Introduction Intelligent Power ControlTypographic Conventions Front Panel Unit DescriptionCircuit Breaker 115 VAC, 20 Amps Back PanelQuick Start Guide Page QuickStartGuide NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Cable Clamp Installation InstallationPower Connection Output Cable Clamp 1OutputCableClampInstallationInput Cable Clamp InstallationDisconnect Timeout Option SwitchesDefault Parameters Option Reset Unit to DefaultsDefault Button / Reset Button Local Console Port Connection Connecting an External ModemConnecting the Network Cable System Mode and User Mode ConfigurationCommunicating with the NPS =AllPlugswithAccess Defining General Parameters NPS Command/Menu ConventionsButtonMode NPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Plug Parameters ConfigurationPage Network Parameters 00-40-05-5e-f3-90Implementing IP Security Configuration Save Configuration Parameters Operation Access the NPS-2HD Command ModeDisplaying Plug Status MrmaioOperation Boot/On/Off CommandsOFF POWER2 or /OF POWER2 and press Enter Automated Mode Default CommandNPS-2HDHeavyDutyNetworkPowerSwitchUsersGuide Login as Different User Other CommandsReset Network Port Exit / DisconnectOperating Tips Manual OperationSending Parameters to a File Saving and Restoring Configuration ParametersRestoring Saved Parameters Console Port Interface Interface DescriptionsModem Port Interface Apx-2Input Connector IEC-320-C19 Inlet SpecificationsApx-4 Customer ServiceTrademark and Copyright Information AppendicesApx-6 Index FrontactoryPanSttigsAddresslIndicators.F4-6 4-6,6-8 OnsolePortA58,643 PowerInletNameOwnrship