Western Telematic NPS-2HD manual QuickStartGuide

QuickStartGuide

5.Exit Command Mode: When you have finished setting Network Parameters, type /X and press [Enter] to exit the command mode at the Console Port.

Note: Only one port may access the NPS command mode at a given time. In order to allow access to the NPS unit via other ports, always exit from the command mode when you are finished communicating with the unit.

6.Connect Network Cable: Connect your network interface to the NPS-2HD Network Port. The Network Port is an RJ45, 10BaseT Ethernet jack, for connection to a TCP/IP network.

Note: The NPS-2HD features a 10BaseT Interface. When connecting to a 100BaseT interface, note that most router switches will autosense to determine if the device is 100BaseT or 10BaseT, and then configure the network interface accordingly. If your router switch does not autosense, then the network interface port must be manually set to 10BaseT.

7.Network Access: Telnet to the NPS's IP address. For example, if the IP address is "119.1.1.1", on a UNIX system the Telnet command would be invoked as follows:

$ telnet 119.1.1.1 [Enter]

After the Telnet connection is established, the NPS should display the System Help Screen and the NPS command prompt should appear, indicating that you have successfully accessed the NPS Command Mode via the Network Port.

3-3