Perle Systems S-1110PP, S-1110DPP manual Installation, Auto-MDIX Jumper Settings

Page 5

Installation

The default DIP switch settings (all switches in the UP position) will work for most installations.

These are the steps required to configure the Perle S-1110P Ethernet media converter:

1.Insert SFP Module (SFP Model only).

2.Set the Auto-MDIX jumper setting (optional).

3.Set the DIP switch settings (if required).

4.Set the Powering Option Jumpers (if required).

5.Install and connect the fiber cable(s).

6.Install and connect the copper cable(s).

7.Power up the media converter.

Auto-MDIX Jumper Settings

Note: The factory settings for Auto-MDIX will work for most installations, but in the rare case that you need to modify the settings, the procedure is below.

For dual copper media converters, each copper interface has an Auto-MDIX jumper bank. To access the Auto-MDIX jumper settings, unscrew the six side screws on the case and remove the cover plate. Locate the MDIX AUTO jumper set as detailed below. By covering or strapping pins 1 and 2, the S-1110P will operate as an MDIX device. By covering or strapping pins 2 and 3, the S- 1110P will automatically detect the Ethernet cable’s polarity. Removing the strapping is the same as AUTO.

Note: The default jumper setting is AUTO

Perle PoE/PoE+ 10/100/1000 Ethernet Media Converter

5

Installation Guide

 

Page 4 Page 6
Image 5
Page 4 Page 6
Contents 1110P 1110PP 1110DP 1110DPP Installation GuidePort Models OverviewDual Copper / PoE DP Connector Mode Wavelength Port Models SFP Port Models SPFAuto-MDIX Jumper Settings InstallationUTP copper Power Power Sourcing PinoutsPoE PoE+Powering Options Jumper Settings Bank DIP SwitchesBank Auto Negotiation copper Switch DIP Switch Settings BankLink Mode Switch Switch Position CopperSwitch Position Fiber Port Fiber Fault Alert SwitchIllustration of the FFA Duplex copper SwitchSwitch Position Copper port Switch Fiber Position Mbps Up default Auto Down Off Speed copper SwitchAuto Fiber Negotiation Switch Switch Position 1 Switch Position 2 Type Loopback Fiber-1 Switch Loopback Fiber-2 SwitchSwitch Position Mode Redundant Primary Switch Fiber Redundancy Switch Dual fiber models onlyInstalling the Simplex Fiber Cable Installing the SFP Fiber ModuleInstalling the Duplex Fiber Cable Attaching the Grounding Lug Installing the Copper CableGrounding the Media Converter Attaching the Power cord strain relief clip Powering up the Perle Media ConverterLED Pattern OperationStatus LED Error conditions Pause Ieee 802.3xy Other FeaturesAuto-MDIX General TroubleshootingNo connectivity MethodNo Power to the PD Fiber Optic Specifications Technical Specifications1110PP-S1SC120U Min Ethernet Copper Cabling Requirements Fiber Cabling RequirementsCompliance Information EN 55022, Class a EN 55024, Class a Laser Safety IECCopyright Warranty / RegistrationContacting Technical Support
Top Page Image Contents