Perle Systems S-1110PP, S-1110DPP manual DIP Switches, Bank

Page 8

DIP Switches

The DIP switches are accessible through the opening in the side of the enclosure.

Bank 1

Bank 2

Bank 1

Bank 2

Note: All switch changes take effect immediately. Switch changes will cycle power to the PD only if the PD Reset switch is set to On or you make changes to the PSE Power switches.

8	Perle PoE/PoE+ 10/100/1000 Ethernet Media Converter
	Installation Guide

Image 8

Contents Installation Guide 1110P 1110PP 1110DP 1110DPPOverview Port ModelsDual Copper / PoE DP Connector Mode Wavelength Port Models SPF Port Models SFPInstallation Auto-MDIX Jumper SettingsPower Sourcing Pinouts UTP copper PowerPoE PoE+Powering Options Jumper Settings Bank DIP SwitchesBank DIP Switch Settings Bank Auto Negotiation copper SwitchLink Mode Switch Switch Position CopperFiber Fault Alert Switch Switch Position Fiber PortIllustration of the FFA Duplex copper SwitchSwitch Position Copper port Switch Fiber Position Mbps Up default Auto Down Off Speed copper SwitchAuto Fiber Negotiation Switch Loopback Fiber-1 Switch Loopback Fiber-2 Switch Switch Position 1 Switch Position 2 TypeSwitch Position Mode Fiber Redundancy Switch Dual fiber models only Redundant Primary SwitchInstalling the Simplex Fiber Cable Installing the SFP Fiber ModuleInstalling the Duplex Fiber Cable Attaching the Grounding Lug Installing the Copper CableGrounding the Media Converter Powering up the Perle Media Converter Attaching the Power cord strain relief clipLED Pattern OperationStatus LED Error conditions Pause Ieee 802.3xy Other FeaturesAuto-MDIX Troubleshooting GeneralNo connectivity MethodNo Power to the PD Technical Specifications Fiber Optic Specifications1110PP-S1SC120U Min Fiber Cabling Requirements Ethernet Copper Cabling RequirementsEN 55022, Class a EN 55024, Class a Laser Safety IEC Compliance InformationCopyright Warranty / RegistrationContacting Technical Support