Perle Systems S-1110PP, S-1110DPP manual Power Sourcing Pinouts, UTP copper Power, PoE+

Power Sourcing Pinouts

Note: The factory settings for Power Sourcing Pinouts will work for most installations as 802.3a and 802at-2009 ( POE/POE+) devices will detect and sync to the correct POE option. However, in the rare case that you need to modify the settings, the procedure is below.

When Power Sourcing is enabled on a copper port, the S-1110P will provide power to the connected PD device over the Ethernet cable (see PSE function on Dip Switch configurations). The wire pairs on the cable used for delivering power will depend on the device. The following options are available.

			PoE Option
	RJ-45
		Alternative A	Alternative B	Legacy
1		positive
	2	positive
3		negative
	4		positive	negative
5			positive	negative
	6	negative
7			negative	positive
	8		negative	positive

UTP (copper) Power

PoE

∙IEEE 802.3af (PoE) up to 15.4 Watts per UTP port.

PoE+

∙IEEE 802at-2009 (PoE+)

∙Up to 30 Watts on a single UTP port model and up to 25.5 Watts per port on a dual UTP port model

∙PoE+ models will also support 802.3af PDs (Type 1) and PoE+ PDs (Type 2)

6	Perle PoE/PoE+ 10/100/1000 Ethernet Media Converter
	Installation Guide