Perle Systems S-1110DPP, S-1110PP manual Powering Options Jumper Settings

Page 7

Powering Options Jumper Settings

In order to select a powering option, the Power Options Jumper settings must be set. Each copper port has a set of Power Option jumpers. To access the Powering Options Jumper settings, unscrew the six side screws on the case and remove the cover plate. Locate the Power Option jumper set and strap the option pins as detailed below.

Perle PoE/PoE+ 10/100/1000 Ethernet Media Converter	7
Installation Guide

Image 7

Contents 1110P 1110PP 1110DP 1110DPP Installation GuidePort Models OverviewDual Copper / PoE DP Connector Mode Wavelength Port Models SFP Port Models SPFAuto-MDIX Jumper Settings InstallationPoE+ Power Sourcing PinoutsUTP copper Power PoEPowering Options Jumper Settings Bank DIP SwitchesBank Switch Position Copper DIP Switch Settings BankAuto Negotiation copper Switch Link Mode SwitchSwitch Position Fiber Port Fiber Fault Alert SwitchSwitch Position Copper port Duplex copper SwitchIllustration of the FFA Auto Fiber Negotiation Switch Speed copper SwitchSwitch Fiber Position Mbps Up default Auto Down Off Switch Position 1 Switch Position 2 Type Loopback Fiber-1 Switch Loopback Fiber-2 SwitchSwitch Position Mode Redundant Primary Switch Fiber Redundancy Switch Dual fiber models onlyInstalling the Duplex Fiber Cable Installing the SFP Fiber ModuleInstalling the Simplex Fiber Cable Grounding the Media Converter Installing the Copper CableAttaching the Grounding Lug Attaching the Power cord strain relief clip Powering up the Perle Media ConverterStatus LED OperationLED Pattern Error conditions Auto-MDIX Other FeaturesPause Ieee 802.3xy Method TroubleshootingGeneral No connectivityNo Power to the PD Fiber Optic Specifications Technical Specifications1110PP-S1SC120U Min Ethernet Copper Cabling Requirements Fiber Cabling RequirementsCompliance Information EN 55022, Class a EN 55024, Class a Laser Safety IECContacting Technical Support Warranty / RegistrationCopyright