Omnitron Systems Technology 10/100M2 user manual SFP Information

Page 30

4.3.4SFP Information

The 10/100M2 module installed with an SFP will provide general and specific information on the SFP. This information is best viewed with SNMP management software. The following is the information available:

4.3.4.1SFP A0 Information Display

This section displays fixed SFP Module information for the following areas.

Identifier Values

Extended Identifier

Connector Values

Transceiver Codes

Encoding Rules

Normal Bit Rate

Link Length

Vendor Name

Vendor OUI

Vendor Revision Number

Laser Wavelength

Options

Vendor Serial Number

Date Code

Diagnostic Monitoring Type

Enhanced Options

SFF-8472 Compliance

4.3.4.2SFP A2 Information Display

This section displays decoded SFP data collected for the following statistics.

Measured Temperature

Measured Vcc

Measured Bias

Measured Tx Power

Measured Rx Power

Temperature High Alarm Setting

Temperature Low Alarm Setting

Temperature High Warning Setting

Temperature Low Warning Setting

Vcc High Alarm Setting

Vcc Low Alarm Setting

Vcc High Warning Setting

Vcc Low Warning Setting

Bias High Alarm Setting

Bias Low Alarm Setting

Bias High Warning Setting

Bias Low Warning Setting

Tx Power High Alarm Setting

Tx Power Low Alarm Setting

Tx Power High Warning Setting

Tx Power Low Warning Setting

Rx Power High Alarm Setting

Rx Power Low Alarm Setting

Rx Power High Warning Setting

Rx Power Low Warning Setting

Page 30

Image 30
Contents Standalone and PLUG-IN Module Table of Contents Overview SA Standalone Plug-InPort Structure Installation Procedure B B B B B B BConfiguring DIP-SWITCHES 1.2 SW2 Fiber Full/Half-Duplex FDX/HDX 1.5 SW5 UTP Full/Half Duplex FDX/HDX These DIP-switches are for factory use only Installing PLUG-IN Modules and Connecting Cables Passwords Management Options screen will be displayed Setting IP and Control Preferences Setting the Chassis Number and Name Setting 10/100M2 Passwords Setting Snmp Preferences Setting SNMPv1/v2c Read and Write Community Names Setting the Snmp Trap IP Host Addresses Enabling/Disabling Soft-switch Reload Access the 10/100M2 Remotely Updating the 10/100M2 Firmware via the Serial Console Port Verify Operation Detailed Module Configuration NMM8919N-0 10/100M2 UTP HDX UTP FDX LEDModule Management Mode Port Configuration UTP To change the ingress rate of the UTP port, select option SFP Information A167EC500000 5 802.3ah Parameters Page OUI Port Vlan Page Tagged Vlan BP B PvidVlan ID VID UTP BP a BP BVlan Table is Empty Vlan ID +1 Vlan ID CNode Loopback To refresh the Port Statistic screen, press Enter 10/100M2 Specifications Cable TypesTroubleshooting Guide Possible CausesUTP Issues Warranty Limitation of Warranty