Passwords

3.4CONFIGURE THE MODULE VIA COMMAND LINE INTERFACE

To configure, attach the 10/100M2 to a DB-9 serial (RS-232) equipped computer with terminal emulation software such as HyperTerminal. The 10/100M2 Serial Console Port (DCE) is a mini DIN-6 female connector which can be changed to a DB-9 connector with the included adapter (Part #8082-0). Attach the ends of a serial cable to the serial port of the PC and the Serial Console Port of the 10/100M2. This is a standard asynchronous serial interface. The pin-outs are illustrated below.

Serial Connector Pin Outs

Start HyperTerminal and select the correct COM Port in the HyperTerminal “Connect To:” window. Set the PC’s serial port to the following:

Bits Per Second:	57,600
Stop Bits:	1
Data Bits:	8
Parity:	NONE
Hardware Flow Control:	NONE

Power the chassis containing the 10/100M2 module and press <ENTER> to bring up a command line prompt on the attached PC.

The module is configured with the following defaults:

IP
IP Address:	192.168.1.220
IP Subnet Mask:	255.255.255.0
Passwords
Serial:	No password assigned
FTP:	No password assigned
Telnet:	public

SNMPv1/v2c Communities

READ:	public
WRITE:	public
SNMPv3 Parameters
User 1 name (read only):	guest
User 2 name (read/write):	admin
User 1 Privacy pwd:	publicguest	User 1 Authen pwd:	publicguest
User 2 Privacy pwd:	privateadmin	User 2 Authen pwd:	privateadmin

Page 11

SNMPv3 Parameters