Omnitron Systems Technology 10/100M2 user manual Configuring DIP-SWITCHES

Page 6

3.2CONFIGURING DIP-SWITCHES

PI

SA

The 10/100M2 plug-in module has two board-mounted DIP-switches. The standalone unit has one bank of DIP-switches. The locations of the DIP-switches are illustrated below.

Switch 1

Switch 8 Switch 1

Switch 8

Left

Bank 2

Bank 1

Right

Up

SW1

Bank 1

Down

SW8

DIP-switch Locations

3.2.1Board-Mounted Bank 1 Settings

PI

SA

DIP-switch Bank 1 is available on both the plug-in and standalone modules. The table indicates the position of the switch; Left/Down or Right/Up. As indicated in the DIP-switch location diagram, Left and Right refers to the plug-in module and Down and Up refers to the standalone module.

PI

(Left/Right)

SA

(Up/Down)

Switch

Left/Down

Right/Up

(Factory Default)

 

 

SW1

Off:

On:

Pause Disable

Pause Enable

 

SW2

FDX:

HDX:

Fiber Full-Duplex

Fiber Half-Duplex

 

SW3

AN:

Man:

UTP Auto-Negotiate

UTP Manual

 

SW4

100:

10:

UTP 100Mbps

UTP 10Mbps

 

SW5

FDX:

HDX:

UTP Full-Duplex

UTP Half-Duplex

 

SW6 - SW8

See Link Mode DIP-Switch Table in Section 3.2.1.6

 

 

 

3.2.1.1SW1 - Pause Disable/Enable “Off/On”

When a port is operating in auto-negotiation, its Pause operation mode is determined by the Pause capability advertised during auto-negotiation between itself and the link partner. The port advertises its Pause capability during auto-negotiation based on the Pause Disable/Enable DIP-switch setting. Setting the Pause DIP-switch to

Page 6

Image 6
Contents Standalone and PLUG-IN Module Table of Contents Overview SA Standalone Plug-InPort Structure Installation Procedure B B B B B B BConfiguring DIP-SWITCHES 1.2 SW2 Fiber Full/Half-Duplex FDX/HDX 1.5 SW5 UTP Full/Half Duplex FDX/HDX These DIP-switches are for factory use only Installing PLUG-IN Modules and Connecting Cables Passwords Management Options screen will be displayed Setting IP and Control Preferences Setting the Chassis Number and Name Setting 10/100M2 Passwords Setting Snmp Preferences Setting SNMPv1/v2c Read and Write Community Names Setting the Snmp Trap IP Host Addresses Enabling/Disabling Soft-switch Reload Access the 10/100M2 Remotely Updating the 10/100M2 Firmware via the Serial Console Port Verify Operation Detailed Module Configuration NMM8919N-0 10/100M2 UTP HDX UTP FDX LEDModule Management Mode Port Configuration UTP To change the ingress rate of the UTP port, select option SFP Information A167EC500000 5 802.3ah Parameters Page OUI Port Vlan Page Tagged Vlan BP B PvidVlan ID VID UTP BP a BP BVlan Table is Empty Vlan ID +1 Vlan ID CNode Loopback To refresh the Port Statistic screen, press Enter 10/100M2 Specifications Cable TypesTroubleshooting Guide Possible CausesUTP Issues Warranty Limitation of Warranty