Omega Vehicle Security zSeries Appendix F Telnet Commands Table, Response 7 EngrLAB 01000010

Page 68

Appendix F TELNET COMMANDS TABLE (continued)

*An example of the internal state of an End Device

Command: EQNG00A

Response: 7 EngrLAB 01000010 2.0

7 is the Device ID (DID) of the End Device. EngrLAB is the name for the End Device.

“01000010” is the bitmap representation of the internal state. The meaning for each bit is described below (bit 7 starts from the left).

2.0 is version of the firmware in the End Device.

Bit 7 shows if the sensor is plugged into the End Device. ‘1’ means there is no sensing device detected.

Bit 6 shows if the communication to the End Device is lost. ‘1’ means there has not been any data received from that particular End Device for 1 minute or 4 times the update rate, whichever is a longer time interval.

Bit 5 shows if there is more than one End Device having the same dip switch configuration. ‘1’ means more than 1 End Device has the same Network ID and Device ID.

Bit 4 shows if there is any pending “identify mode request” command for the End Device. ‘1’ means a “start” command is issued.

Bit 3 not used

Bit 2 shows if there is any pending “reset” command for the End Device. ‘1’ means a “reset” command is issued.

Bit 1 shows the source of power supply to the End Device. ‘1’ means it’s powered by an adapter and ‘0’ means it’s powered by batteries.

Bit 0 shows the operation mode of the End Device. ‘1’ means it is in identification mode and ‘0’ means it is in normal operation mode.

Based on the above information, End Device # 7 has not been communicating with the Coordinator and its power is supplied by an adapter.

62

Image 68

Contents User’sGuide Page Table of Contents Appendix a Appendix BAppendix C Appendix DList of Figures Page Features Description Part IntroductionEMC Considerations Description ZSeries Wireless System on the Ethernet Network Rear Part HardwareFrom TOP to Bottom Disassembly End Device Disassembly of the End DeviceParts of the Coordinator Dimensions and Mounting Coordinator Mounting the CoordinatorDIP Switches DIP Switch Setup Device ID did Device ID did 8 Position DIP Switch SetupDefinitions DIP Switch Setup Network ID NIDNID DIP Switch Setup Ethernet Coordinator Ethernet 4 Position DIP Switch Setup10 RJ45 Pinout 2 10Base-T Crossover Wiring Dhcp Part Network ConfigurationNetwork Protocols IP Address Default IP AddressDNS Network Connections SectionUsing the Telnet or Web browser Part OperationsIConnect Software Accessing the zSeries System for Configuration Setting a New IP Address over the Network Access ControlWireless Sensors Home Coordinator’s Configurations and OperationsPower Up Device Get Readings from the End Device Select Readings by GroupTheReadings fields are defined as follows Java Runtime Environment Setup Java Runtime Environment 1.4 Setup instructions10 Java 1.5.x.x. Screen Shots Accessing Coordinators units over Peer-to-Peer network Accessing Coordinators units using the internetDiagnostics Java Policy Java Policy file and copy it onto a folderGrant codeBase http//192.168.1.200 Permission java.security.AllPermissionDjava.security.policy=C\0JAVAPOLICY\javapolicy.txt 12 Java PolicyChart 13 Select Chart by GroupChart Diagnostic 15 DiagnosticConfiguration 16 ConfigurationSensor Setup 17 Sensor Setup by Group18 Sensor Setup Update Checked BoxSensor Parameters Web Server Host NameTelnet Setup HTTPget ProgramHTTPget using Port Httpget -r -S Erdgall 192.168.1.1352000 -C1 -qWhere 2000HTTPget and ARP to Setup Device IP Address Arp -s 192.168.1.200 00-03-34-00-00-06-b6Httpget -r -S 00000000 192.168.1.2001 where ARP Protocol22 ARP Commands and Responses ILog Software 23 iLog Software Logging Data for End Deice #1, 3Installation Mail Notifier SoftwareEmail Address Setup Email SetupDevice Setting and Configuration EQNF003Alarm Editor Mail Notifier Device SettingGeneral Deployment Guidelines PartEnvironment / Operating Conditions Control Room Office Operation in BuildingsWith Line-of-Sight Distance feet Radius feetCasing and Closure Around the Antenna Material Type Possible Signal ReductionWithout Line-of-Sight Fine Adjustment in Performance ChannelsPart 6 Specifications Relative HumidityApprovals DIP Switches DhcpAppendix Aglossary Appendix BIP Address Appendix CIP Netmask Address Class Mask Binary Value Mask Decimal ValueOr Dotted Notation Mask Dotted Notation Mask Binary Mask BitsAscii Chart Dec Hex Binary AsciiDec Binary Char No Parity No parityChar Equiv Appendix D Ascii Chart ContinuationDec Hex Ctrl Key Ascii Control Codes Definition Appendix E ILog Error Messages Error # Description Telnet Commands Table ErdgAppendix F Telnet Commands Table Response 7 EngrLAB 01000010Lost Appendix G Frequently Asked Questions FAQOpen Page WARRANTY/DISCLAIMER Shop on line at omega.com