M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
Figure E.2b: Bench Test setup drawing for 10” TS model.
Note that one device is higher than the other and shifted over to the side so that only one transmitter from each device is facing opposite the other device’s receiver.
Telescopes
The Rear Door hangs over the TereScope basis
Figure E.3: Active Transmitters (Shown Darkened).
Bench Test for TS700 and TS800 series with JAH-L
The Aiming head of the TS700 and TS800 series was changed from
Therefore the TereScopes are delivered to the clients not mounted on the Aiming head. In this case, when the back door is opened and secured in its place, it hangs over the TereScope basis and the TereScope can’t stand straight and leans on the door, which can damage the door’s hinges.
Therefore there are two ways to perform the Bench test, as can be seen on the following figures.
The first way is to mount the TereScope on its Aiming head and do all the tests before installation with the alignment head.
Rear Door fixed
Figure E.4: Bench test with TereScopes mounted on the Aiming Head (JAH-L.)
64