Multi-Tech Systems MT3334SMI manual Command &Zy=x Store Dialing Command, Bn Transmit Break

		Chapter 2 - AT Commands, S-Registers, and Result Codes
Command: &Zy=x Store Dialing Command
Values:		y = 0–3 (callback security disabled) or 0–29 (callback security enabled)
		x = Dialing command
Default:		None
Description:		Stores dialing command x in memory location y. Dial the stored number using the command
		ATDS=y. See also the #CBSn command. For callback security options, see Chapter 6.
Command:	\An	Select Maximum MNP Block Size
Values:		n = 0, 1, 2, or 3
Default:		3
Description:	\A0	64-character maximum.
	\A1	128-character maximum.
	\A2	192-character maximum.
	\A3	256-character maximum.
Command:	\Bn	Transmit Break
Values:		n = 0–9 in 100 ms units
Default:		3
Description:		In non-error-correction mode only, sends a break signal of the specified length to a remote
		modem. Works in conjunction with the \K command.
Command:	\Jn	Data Buffer Control
Values:		n = 0
Default:		0
Description:	\J0	Enable data buffer—serial port speed is independent of connect speed.
	\J1	Disable data buffer—serial port speed is forced to the line speed.
Command:	\Kn	Break Control
Values:		n = 0–5
Default:		5
Description:		Controls the response of the modem to a break received from the computer, the remote modem,
		or the \B commnd. The response is different for each of three different states.
		Data mode. The modem receives the break from the computer:
	\K0	Enter online command mode, no break sent to the remote modem.
	\K1	Clear data buffers and send break to the remote modem.
	\K2	Same as \K0.
	\K3	Send break immediately to the remote modem .
	\K4	Same as \K0.
	\K5	Send break to the remote modem in sequence with the transmitted data.
		Data mode. The modem receives the break from the remote modem:
	\K0	Clear data buffers and send break to the computer.
	\K1	Same as \K0.
	\K2	Send break immediately to the computer.
	\K3	Same as \K2.
	\K4	Send break to the computer in sequence with the received data.
	\K5	Same as \K4.
		Online command mode. The modem receives a \Bn command from the computer:
	\K0	Clear data buffers and send break to the remote modem.
	\K1	Same as \K0.
	\K2	Send break immediately to the remote modem.
	\K3	Same as \K2.
	\K4	Send break to the remote modem in sequence with the transmitted data.
	\K5	Same as \K4.

MT3334SMI 25