Multi-Tech Systems RAS96 manual Important Safety Instructions, Iii

Page 3

Important Safety Instructions

Caution: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

The RAS96 RASCard circuit board includes a battery that maintains the RASCard’s setup information when it is turned off or disconnected from power. The battery can maintain the setup information for approximately 10 years with no external power, and longer when the RASCard is turned on and operating normally. This battery is soldered onto the circuit board and cannot be replaced by the user.

Note: There is a possibility of excessive battery drain if the RASCard is set on a metal table or stored in an anti-static bag.

If, for some reason, the RASCard’s battery should fail, please contact Multi-Tech Technical Support at +(763) 717-5863 for replacement instructions.

CommPlete Communications Server

iii

Image 3

Contents RAS96 RASCard E1 User Guide RAS96 RASCard User Guide Iii Important Safety InstructionsTable of Contents Appendix C Post Codes Solving ProblemsPage Introduction Manual Organization IntroductionAppendix D Approved Memory Technical SpecificationsAppendix B Post Messages Appendix C Post CodesHumidity range 20-90% noncondensing RASCard Description RAS96 RASCard Memory BanksJ17 Watchdog Timer JumpersJ14, J15, J16, J18 CPU Frequency Selection Internal Connectors J35 Video External ConnectorsJ2 Power Connector J22 E1 AlarmE1 Status LEDs LED IndicatorsFront Panel Ethernet Status LEDsSwitches Power SwitchReset Switch Page Installation Safety Warnings Pre-Installation NotesInstallation Procedure Installation Page Bios Setup Utility Starting Setup Using Setup Case of ProblemsGetting Help Power Management Setup Standard Cmos SetupBios Features Setup Chipset Features SetupPCI Configuration Setup Password SettingLoad Bios Defaults IDE HDD Auto Detection Load Setup DefaultsExit Without Saving Save and Exit SetupHard Disks Standard Cmos SetupDate TimeDrive a Type / Drive B Type VideoCGA Memory Halt OnVirus Warning Bios Features SetupEnabled DisabledBoot Up NumLock Status Quick Power On Self TestBoot Sequence Boot Up Floppy SeekTypematic Rate Chars/Sec Typematic Rate SettingGate A20 Option Memory Parity CheckC8000 Cffff Shadow/DC000 Dffff Shadow Typematic Delay MsecVideo Bios Shadow Security OptionChipset Features Setup System Bios CacheableDram Timing Memory Hole At 15M-16M Video Bios CacheableBit I/O Recovery Time IDE HDD Block ModePCI Bursting On-Chip Primary PCI IDEPCI Concurrancy PCI StreamingPower Management Power Management SetupHDD Power Down Doze ModeStandby Mode Suspend ModeDrive Ports Accessed Power Down ActivitiesCOM Ports Accessed LPT Ports AccessedPCI Configuration Setup Slot x Using INT#1st/2nd/3rd/4th Available IRQ PCI IDE IRQ Map to PCI IRQ Activated byEnter Password Password SettingPage E1 Daughter Cards E1 Overview SpecificationsE1 Glossary E1 Basics Dnis digits Signaling OptionsE1 Frame Formats E1 Line CodingCountry Selection E1 Facility Termination Pin SignalTest Modes RJ-11 Alarm JackPCB Description E1 Line Monitoring JackLine Coding Configuration of the E1 Daughter CardOrdering an E1 Line Channelized E1 line with 30 DS-0 channels E1 Frame FormatFactory Defaults To Configure the E1 Daughter CardCommand Example E1 CommandsRAS96 RASCard User Guide E1 Daughter Card RAS96 RASCard User Guide E1 Status LEDs E1 Command MessagesFunctional Description Solving Problems RASCard has no video TroubleshootingInvalid time, date or setup COM1 port does not respond correctlyKeyboard does not respond to key strokes Memory Upgrade Calling Technical Support Diagnostic TestsRAS96 RASCard User Guide Appendixes Appendix a Connector Pinouts Keyboard Connector J11Video Connector J35 E1 Alarm Connector J22 COM1 Connector J3Drive Power Connector J13 Pin Floppy Disk Drive Connector J27IOCS16 Hard Disk Connector J6Figure A-7. IDE connector IDE Connector J21Error Messages Appendix B Post MessagesPost Beep Memory Address Error at Memory parity Error atMemory Verify Error at Offending Segment Code Name Description Appendix C Post CodesPost Codes E1-EF Capacity Speed Type Manufacturer Part Number Usable MB Appendix D Approved MemoryAppendix E Regulatory Information EMC, Safety and Terminal Directive Compliance