Multi-Tech Systems RAS96 On-Chip Primary PCI IDE, PCI Concurrancy, PCI Streaming, PCI Bursting

Page 39

4 BIOS Setup Utility

On-Chip Primary PCI IDE

As stated above, your system includes a built-in primary IDE controller, which operates on the PCI bus. This setup item allows you to either enable or disable the primary controller.

Enabled

Primary IDE controller used (Default).

Disabled

Only one PCI device can be active at a time.

PCI Concurrancy

PCI concurrency means that more than one PCI device can be active at a time.

Enabled

Multiple PCI devices can be active (Default).

Disabled

Only one PCI device can be active at a time.

PCI Streaming

Data is typically moved to and from memory and between devices in discrete chunks of limited sizes. This is because the CPU is being used in the exchange. On the PCI bus, data can be streamed, that is, much larger chunks can be moved without the use or intervention of the CPU.

Enabled

Streaming allowed on the PCI bus (Default).

Disabled

Streaming off for the PCI bus.

PCI Bursting

The PCI bus supports a mode by which large amounts of data is moved in short intense bursts. This item allows you to turn this feature on or off.

Enabled

Bursting allowed on the PCI bus (Default).

Disabled

Bursting off for the PCI bus.

CommPlete Communications Server

33

Image 39
Contents RAS96 RASCard E1 User Guide RAS96 RASCard User Guide Iii Important Safety InstructionsTable of Contents Appendix C Post Codes Solving ProblemsPage Introduction Manual Organization IntroductionAppendix D Approved Memory Technical SpecificationsAppendix B Post Messages Appendix C Post CodesHumidity range 20-90% noncondensing RASCard Description RAS96 RASCard Memory BanksJ17 Watchdog Timer JumpersJ14, J15, J16, J18 CPU Frequency Selection Internal Connectors J35 Video External ConnectorsJ2 Power Connector J22 E1 AlarmE1 Status LEDs LED IndicatorsFront Panel Ethernet Status LEDsSwitches Power SwitchReset Switch Page Installation Safety Warnings Pre-Installation NotesInstallation Procedure Installation Page Bios Setup Utility Starting Setup Using Setup Case of ProblemsGetting Help Power Management Setup Standard Cmos SetupBios Features Setup Chipset Features SetupPCI Configuration Setup Password SettingLoad Bios Defaults IDE HDD Auto Detection Load Setup DefaultsExit Without Saving Save and Exit SetupHard Disks Standard Cmos SetupDate TimeDrive a Type / Drive B Type VideoCGA Memory Halt OnVirus Warning Bios Features SetupEnabled DisabledBoot Up NumLock Status Quick Power On Self TestBoot Sequence Boot Up Floppy SeekTypematic Rate Chars/Sec Typematic Rate SettingGate A20 Option Memory Parity CheckC8000 Cffff Shadow/DC000 Dffff Shadow Typematic Delay MsecVideo Bios Shadow Security OptionChipset Features Setup System Bios CacheableDram Timing Memory Hole At 15M-16M Video Bios CacheableBit I/O Recovery Time IDE HDD Block ModePCI Bursting On-Chip Primary PCI IDEPCI Concurrancy PCI StreamingPower Management Power Management SetupHDD Power Down Doze ModeStandby Mode Suspend ModeDrive Ports Accessed Power Down ActivitiesCOM Ports Accessed LPT Ports AccessedPCI Configuration Setup Slot x Using INT#1st/2nd/3rd/4th Available IRQ PCI IDE IRQ Map to PCI IRQ Activated byEnter Password Password SettingPage E1 Daughter Cards E1 Overview SpecificationsE1 Glossary E1 Basics Dnis digits Signaling OptionsE1 Frame Formats E1 Line CodingCountry Selection E1 Facility Termination Pin SignalTest Modes RJ-11 Alarm JackPCB Description E1 Line Monitoring JackLine Coding Configuration of the E1 Daughter CardOrdering an E1 Line Channelized E1 line with 30 DS-0 channels E1 Frame FormatFactory Defaults To Configure the E1 Daughter CardCommand Example E1 CommandsRAS96 RASCard User Guide E1 Daughter Card RAS96 RASCard User Guide E1 Status LEDs E1 Command MessagesFunctional Description Solving Problems RASCard has no video TroubleshootingInvalid time, date or setup COM1 port does not respond correctlyKeyboard does not respond to key strokes Memory Upgrade Calling Technical Support Diagnostic TestsRAS96 RASCard User Guide Appendixes Appendix a Connector Pinouts Keyboard Connector J11Video Connector J35 E1 Alarm Connector J22 COM1 Connector J3Drive Power Connector J13 Pin Floppy Disk Drive Connector J27IOCS16 Hard Disk Connector J6Figure A-7. IDE connector IDE Connector J21Error Messages Appendix B Post MessagesPost Beep Memory Address Error at Memory parity Error atMemory Verify Error at Offending Segment Code Name Description Appendix C Post CodesPost Codes E1-EF Capacity Speed Type Manufacturer Part Number Usable MB Appendix D Approved MemoryAppendix E Regulatory Information EMC, Safety and Terminal Directive Compliance