MaxTech V.32bis, V.42bis user manual Section Five Result Codes

Page 33

S17	Reserved
S18	Modem test timer	0-255/seconds	0
S19	Reserved
S20	Reserved
S21	DTR, DCD, DSR, and	Bit-mapped
	Long Space Disconnect
S22	Speaker and response	Bit-mapped
S23	RDL, DTE data rate,	Bit-mapped
	parity,and guard tone
S24	Reserved
S25	DTR delay	0-100/seconds	5
S26	RTS/CTS delay interval	0-255/0.01 second	1
S27	Async operation, CCITT/	Bit-mapped
	Bell mode
S28	Reserved
S29	Reserved
S30	Sleep mode time	0-90/seconds	10
S37	Maximum line speed	0-11	0
S90	Disconnect timer	0-255/seconds	0
S108	Retrain options	0-3	2
S109	Line Speed permitted	2-62	62

Section Five - Result Codes

BASIC RESPONSE CODES

OK	0	CONNECT	1
RING	2	NO CARRIER	3
ERROR	4	CONNECT 1200	5
NO DIALTONE	6	BUSY	7
NO ANSWER	8	CONNECT 2400	10
CONNECT 4800	11	CONNECT 7200	12
DATA	13	CONNECT 9600	14
FAX	15	CONNECT 12000	16
CONNECT 14400	17	+FCERROR	+F4

MODIFIED RESPONSE CODES (\V1)

CONNECT 300/REL	22	CONNECT 1200/REL	24
CONNECT 2400/REL	25	CONNECT 4800/REL	26
CONNECT 7200/REL	27	CONNECT 9600/REL	28
CONNECT 12000/REL 29		CONNECT 14400/REL	30

EXTENDED RESPONSE CODES (\V2)

CONNECT 300/REL-MNP	32
CONNECT 1200/REL-MNP	34
CONNECT 2400/REL-MNP	35
CONNECT 4800/REL-MNP	36

13

Image 33

Contents Contents Unpacking Your Modem Hardware InstallationFasten the retaining bracket Software Installation/ConfigurationPage Devices in your computer cannot share an IRQ with COM Port and Interrupt SettingsUsing Your Modem Testing Your Modem After InstallationWhere To Go From Here Executing CommandsCommand Structure Basic AT Commands Extended AT Commands Guard tone disabled Mode after DTR toggleForce DSR Signal High on Enable Trellis Coding @22bis auto-retrain enabled 22bis auto-retrain disabledEnable Auto Fall Forward/Back Disable Auto Fall Forward/BackFax Class 1 Commands Voice Mode Commands S Registers Function Range/units Default Basic Response Codes Modem does not respond to commands Modem does not dialModem dials but does not connect Modem makes a connection but no data appears on your screen High pitch tone is heard whenever you answer the phoneModem exhibits poor voice record or playback Uart FCC ComplianceDOC Compliance Information FCC Class B StatementDisclaimer, Copyright, And Other Notices Section One Introduction Software Installation/Configuration COM Port and Interrupt Settings Switch Block SW-1 Location Switch Block Settings Testing Your Modem After Installation Ccitt mode Bold text Command Function Manually answer incoming callOriginate calls in answer mode With AT or follow with EnterCommands are not echoed Recall factory default configuration Resets modem after DTR toggleToggle Hz guard tone\A3 MNP/V.42/V.42bis Commands\Q3 Switch to reliable link from normal link S Registers Register Function Range/units DefaultSection Five Result Codes Section Six Troubleshooting Modem does not dial Power 75 W Section Eight Support and Service DOC Compliance Information Disclaimer, Copyright, And Other Notices