MaxTech V.32bis, V.42bis user manual Disclaimer, Copyright, And Other Notices

Page 39

themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.

NOTICE: The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overload- ing. The termination on a loop may consist of any combination of devices subject only to the requirement that the sum of the Load Numbers of all the devices does not exceed 100.

9.4 Disclaimer, Copyright, And Other Notices

The information contained in this manual has been validated at the time of this manual's production. The manufacturer reserves the right to make any changes and improvements in the product described in this manual at any time and without notice. Conse- quently the manufacturer assumes no liability for damages in- curred directly or indirectly from errors, omissions or discrepan- cies between the product and the manual.

All registered trademarks are the property of their respective owners.

Copyright © 1995 All rights reserved. No reproduction of this document in any form is permitted without prior written authori- zation from the manufacturer.

First Edition

GZ/DR - Version 1.1

19

Image 39
Contents Contents Unpacking Your Modem Hardware InstallationFasten the retaining bracket Software Installation/ConfigurationPage Devices in your computer cannot share an IRQ with COM Port and Interrupt SettingsUsing Your Modem Testing Your Modem After InstallationWhere To Go From Here Executing CommandsCommand Structure Basic AT Commands Extended AT Commands Enable Trellis Coding @ Mode after DTR toggleGuard tone disabled Force DSR Signal High onDisable Auto Fall Forward/Back 22bis auto-retrain disabled22bis auto-retrain enabled Enable Auto Fall Forward/BackFax Class 1 Commands Voice Mode Commands S Registers Function Range/units Default Basic Response Codes Modem does not respond to commands Modem does not dialModem dials but does not connect Modem makes a connection but no data appears on your screen High pitch tone is heard whenever you answer the phoneModem exhibits poor voice record or playback Uart FCC ComplianceDOC Compliance Information FCC Class B StatementDisclaimer, Copyright, And Other Notices Section One Introduction Software Installation/Configuration COM Port and Interrupt Settings Switch Block SW-1 Location Switch Block Settings Testing Your Modem After Installation With AT or follow with Enter Bold text Command Function Manually answer incoming callCcitt mode Originate calls in answer modeCommands are not echoed Hz guard tone Resets modem after DTR toggleRecall factory default configuration Toggle\A3 MNP/V.42/V.42bis Commands\Q3 Switch to reliable link from normal link S Registers Register Function Range/units DefaultSection Five Result Codes Section Six Troubleshooting Modem does not dial Power 75 W Section Eight Support and Service DOC Compliance Information Disclaimer, Copyright, And Other Notices