MaxTech V.32bis, V.42bis user manual Contents

Page 1

High Performance

V.32bis/V.42bis

14,400 BPS Internal

FAX/Voice/Data

Modem

Featuring Advanced

Speakerphone Functions

User's Manual

	Contents
Section One	Introduction	1
Section Two	Installation	1
Section Three AT Command Set		6
Section Four	S Register Summary	12
Section Five	Result Codes	13
Section Six	Troubleshooting	14
Section Seven Specifications		16
Section Eight	Support And Service	17
Section Nine	FCC, DOC, Copyright And
	Other Notices	17

Part #MAN0017 Rev 1.1

CL-MD1414ECT-SP

Image 1

Contents Contents Unpacking Your Modem Hardware InstallationFasten the retaining bracket Software Installation/ConfigurationPage Devices in your computer cannot share an IRQ with COM Port and Interrupt SettingsUsing Your Modem Testing Your Modem After InstallationExecuting Commands Where To Go From HereCommand Structure Basic AT Commands Extended AT Commands Guard tone disabled Mode after DTR toggleForce DSR Signal High on Enable Trellis Coding @22bis auto-retrain enabled 22bis auto-retrain disabledEnable Auto Fall Forward/Back Disable Auto Fall Forward/BackFax Class 1 Commands Voice Mode Commands S Registers Function Range/units Default Basic Response Codes Modem does not dial Modem does not respond to commandsModem dials but does not connect High pitch tone is heard whenever you answer the phone Modem makes a connection but no data appears on your screenModem exhibits poor voice record or playback Uart FCC ComplianceDOC Compliance Information FCC Class B StatementDisclaimer, Copyright, And Other Notices Section One Introduction Software Installation/Configuration COM Port and Interrupt Settings Switch Block SW-1 Location Switch Block Settings Testing Your Modem After Installation Ccitt mode Bold text Command Function Manually answer incoming callOriginate calls in answer mode With AT or follow with EnterCommands are not echoed Recall factory default configuration Resets modem after DTR toggleToggle Hz guard tone\A3 MNP/V.42/V.42bis Commands\Q3 Switch to reliable link from normal link S Registers Register Function Range/units DefaultSection Five Result Codes Section Six Troubleshooting Modem does not dial Power 75 W Section Eight Support and Service DOC Compliance Information Disclaimer, Copyright, And Other Notices