MaxTech V.32bis, V.42bis Zn=x =0-3, 22bis auto-retrain disabled, 22bis auto-retrain enabled

&Zn=x	n=0-3	Store telephone number x into non-volatile
		RAM
%E_	%E0	V.22bis auto-retrain disabled
	%E1	V.22bis auto-retrain enabled
%G_	%G0	Enable Auto Fall Forward/Back
	%G1	Disable Auto Fall Forward/Back

3.5	MNP/V.42/V.42bis Commands
%An	n=0-	Set auto-reliable fallback character to n (where
	127	n = 0 to 127,ASCII). Requires the \C2 setting
%C_	%C0	Disable MNP Class 5 data compression
	%C1	Enable MNP Class 5 data compression
\A_	\A0	64-character maximum MNP block size
	\A1	128-character maximum MNP block size
	\A2	192-character maximum MNP block size
	\A3	256-character maximum MNP block size
\Bn	n=1-9	Send a 1/10 second line break to the modem,
		where n = 1 to 9. At normal connect, the
		default is 3
\C_	\C0	Do not buffer data during LAPM/MNP
		handshaking
	\C1	Buffer all data for 4 seconds, until receiving
		200 characters or until a packet is detected
	\C2	Do not buffer data; switch to normal mode
		when fallback character is detected
\G_	\G0	Disable DCE flow control
	\G1	Enable DCE flow control
\J_	J0	Disable serial port data rate adjustment
		(keep high data rate between DTE and
		modem, regardless of modem-to-modem
		data rate)
	J1	Enable serial port data rate adjustment so
		serial data rate automatically adjusts to match
		the modem-to-modem data rate
\Kn	n=0-5	Set break control, where n= 0 to 5. Default
		is 5
\N_	\N0	Normal data-link only
	\N1	Direct data-link only
	\N2	MNP data link only
	\N3	V.42/MNP/Normal data link

10