LSI SAS6160 manual Maximum password length is 32 characters, Matrix, Password, Create Zone Set

Chapter 3: SAS Domain Manager Graphical User Interface Domain Tab LSISAS6160 SAS Switch User Guide

3.6.4Manually Configure Zone Sets The Manually Configure Zone Sets commands enable you to manually create, view, activate/deactivate, and delete zone sets.

3.6.4.1Change Zone Manager Use the Change Zone Manager Password command to change the password used to

Password	manage the zoning expanders in the domain. When the window appears, type the
	current password in the indicated field. Then type the new password and type it again
	to confirm it. Passwords are text strings that consist of any valid ASCII character. The
	maximum password length is 32 characters.
	If you enter a null string, the password is set to its default value, ZERO (32 bytes of
	binary 0), as defined by the SAS 2.0 specification.
3.6.4.2 Create Zone Set	Use the Create Zone Set command to create a new zone set. You can click on the matrix
	to indicate that both zone groups in the associated row/column may communicate
	with one another. A blank cell indicates that the two zone groups may not
	communicate. A dash in a cell indicates an illegal selection because of a phy conflict
	between zone groups. A phy can be a member of one zone group per zone set.
	To see the details of a particular zone group, click the zone group link in the left column
	of the matrix.

Figure 10: Create Zone Set

Page 46 LSI Corporation September 2010