LSI SAS6160 manual „ zonegroup add name sas addressaliasphy, „ zonegroup create name

Chapter 4: SAS Domain Manager Command Line Interface SDM-CLI Commands LSISAS6160 SAS Switch User Guide

4.2.8	Zonegroup Command	(Intra-Domain) Use the zonegroup command to manage zone groups and zone
		group membership. Zonegroup commands have no effect on the active zone set until
		you reactivate it.
		Authority: Admin
		Syntax:

zonegroup add <name> (<sas_address><alias>):<phy> zonegroup create <name>

zonegroup delete ((single <name>)(all [noconfirm])) zonegroup remove <name> (<sas_address><alias>):<phy> zonegroup rename <old> <new>

Usage:

„zonegroup add <name> (<sas address><alias>):<phy>

Adds a phy to an existing zone group.

NOTE: Phys internal to the ZPSDS must be in Zone Group 1. Therefore, exclude them from this command.

„zonegroup create <name>

Creates a new zone group. The zone group name can have a maximum of

32 characters. Valid characters are 0 through 9, A through Z, a through z, # (pound), - (dash), and _ (underscore).

„zonegroup delete single <name>

Deletes a single zone group.

NOTE: You cannot delete a zone group if it is currently a member of a zone set. This restriction also applies to the zonegroup delete all command.

„zonegroup delete all [noconfirm]

Deletes all zone groups. If you specify the [noconfirm] option, the action occurs immediately without an additional confirmation prompt. Otherwise, SDM first prompts you to confirm the action.

„zonegroup remove <name> (<sas address><alias>):<phy>

Removes a phy from an existing zone group.

„zonegroup rename <old> <new>

Renames an existing zone group.

Page 64 LSI Corporation September 2010