Liebert GXTTM user manual Stabilisers/Levelling Feet

Stabilisers/Levelling Feet

When the UPS is located in its final position before or after wiring, it is necessary to fit stabiliser brackets and, if necessary, adjust the levelling feet. If the UPS is wired using a rigid wiring system, then movement of the UPS must be prevented by winding down the 4 levelling feet under the UPS as shown below. For UPS wired with flexible cables, this is optional. Note- Access to the levelling feet is obstructed by the stabiliser brackets, on the GXT10000 models.

Adjust the levelling feet as necessary using a 12mm open ended spanner/wrench. DO NOT LOOSEN THE LARGER NUT ABOVE, AS THIS FIXES THE LEVELLING FEET TO THE CHASSIS.

Attach the stabilising brackets as follows.

GXT6000 models:

1.Using a Phillips-head screwdriver, remove the screws(4) from each of the bottom corners of the side panels.

2.Attach the stabilising brackets to each corner using screws just removed.

GXT10000 models :

1.Using a Phillips-head screwdriver, remove the three inner-most screws at the base of both side panels.

2.Attach the stabilisers fixing with the screws just removed.

10 kVA 6 kVA

12 mm

Levelling Feet Adjustment Diagram

20