TFTP Troubleshooting | Troubleshooting |
B.3 TFTP Troubleshooting
If the TFTP request fails even though you have conÞgured your host to respond to the request, check the areas discussed in the following table.
| Table |
|
|
Area to Check | Explanation |
|
|
|
|
Is TFTP enabled on | Ensure that the /etc/inetd.conf Þle has an uncommented line |
the loadhost? | enabling the TFTP daemon. Machines may have the TFTP daemon |
| line commented out. |
| If the /etc/inetd.conf Þle has to be modiÞed, the TCP/IP server |
| process (daemon) has to be told of this via a signal. Find the process |
| ID (PID) of the inet daemon, and then signal the process. Normally, |
| the process is signalled by sending it a HUP signal (kill |
| nnnnn). |
Is the Þlename | The name and case of the software download Þle must be correct. |
correct? | The software Þle names are uppercase, but can be renamed. The |
| server will look for uppercase names by default. |
|
|
B.4 Entering Commands at the Boot Prompt
If the Boot prompt appears on the serial console instead of the Local prompt, one of two things may be wrong. Either the MSS does not have enough information to boot, or the network or ßash boot has failed. If pressing the Return key does not display a prompt, press any other key. The Boot prompt should appear.
If the MSS does not have enough information to boot, or the network or ßash boot has failed, it will print a message to the console and wait ten seconds for serial port activity. If it detects serial port activity, it will continue booting provided the ßash is good. However, if the user presses a key during that ten second time period, the MSS will display the Boot prompt.
NOTE: If the message ÒWill attempt another download in x minutesÓ is displayed, press any key for the Boot prompt.
A series of commands called Boot ConÞguration Program (BCP) commands can be entered at the Boot prompt to conÞgure the MSS. These commands are a subset of the entire MSS command set.
B - 4