GE CBR-PB3-WD installation manual HyperTerminal Setup, Equipment Required

Page 26

10 HyperTerminal Setup

Manual configuration can also be completed using Windows HyperTerminal in lieu of the dipswitches. Manual configuration should only be used if the “POS Device Selection” does not conform to your specific device because baud rates or protocols are slightly different than the default values for the selected device.

10.1 Equipment Required

q(1) Windows 98/NT/2000/XP Desktop or Laptop PC.

q(1) DB9F to RJ45 cable (included with your unit).

Configuration using Windows HyperTerminal uses the supplied RJ45-to-DB9 cable provided with your unit. Disconnect the PB3 unit from the DVMRe and hook-up the cable as follows:

The RJ45 end connects to the outside receptacle of Port 1 of the PB3 unit and the DB9 end connects to your PC’s COM Port (typically COM1).

IMPORTANT: If you program the ProBridge via NOTE HyperTerminal you must BACKUP (Save) the

program information via the BACKUP option so that everytime the unit is powered up, the settings you configured will be used.

Kalatel CBR-PB3-WD

26

0150-0261A

Image 26

Contents Kalatel CBR-PB3-WD ProBridge Receipt Printer Interface Copyright Information Table of Contents Cable Specifications Warranty and Service 14.1 Factory Service 14.2 WarrantyKalatel CBR-PB3-WD Description Additional Equipment Provided by InstallerCBR-PB3-WD ProBridge CompatibilityBefore You Begin Installation SummaryHow to Use this Manual Kalatel Components4310-0007 120VAC Power Supply Installation EnvironmentPower 4310-0008 220VAC Power Supply Tolerance ±10% Frequency 50 Hz Power Supply OutputProBridge Diagram Default Factory Dipswitch Settings Important Switch AssignmentsConnection Diagram DVMRe TriplexTermination Switch Sample Systems TerminationDetailed Installation Steps PB3 Physical InstallationProcess several POS transactions at the Cash Register Configuring the PB3 for POS InterfaceAssociating ECR data to a specific camera Kalatel CBR-PB3-WD 0150-0261A Display Memory Demo Simulated Message ModeSpecial Functions Reset Clear Memory Kalatel CBR-PB3-WD 0150-0261A Up Off = U Down On = D TroubleshootingSwitch Setting Baud Rate Port 1200 2400 4800 9600 14.4k 19.2k 38.4kTroubleshooting Guide Text to Camera Address SW1 DipswitchesDipswitch 5 Camera Assignment Dipswitch Numbers SW1 Baud Rate Manual Switch ConfigManual Dipswitch Settings Available Protocol Kalatel CBR-PB3-WD 0150-0261A HyperTerminal Setup Equipment RequiredSetting up the ProBridge for HyperTerminal Operation Manual HyperTerminal Configuration Setup Option 2 Port #2 Menu Selection 2 Protocol Options q AsynchronousMenu Selection 4 Parity Menu Selection 5 Mode The available selections areMenu Selection 3 Baud Rate Menus Selection 7 Device Type q Generic Receipt PrinterCommunicationsRS-232Port 1 ATM Activate DVMRe-CS/CD Setup11 PB3-POS with DVMRe -CD/CS Units Final Testing RJ-45 Connector DB9F Connector Cable SpecificationsRJ-45 Connector ProBridge to Triplex DVMRe-CTDB9F Connector DB9F and DB9M Connector Communication Type RS-485 Connector Type RJ45, RJ45RJ45 Connector ProBridge to ProBridge CableSpecifications Warranty Warranty and ServiceFactory Service Factory AddressAdvance Replacement Policy